Installation Manual

Kingfisher Company, inc. STAR-ELT Manual
KCi #99420-MAN Rev 0.6 Page 25 of 29
18.1 Table 1: STAR-ELT Transmitter Parameters
Accessibility is from the three different functional levels, each accessible with a different
password. “S” means that the parameter can be set from a given level. “V” means that the
parameter can be viewed from a given level but not changed. A blank field means that the
parameter cannot be changed or viewed at that functional level.
STAR Transmitter
Parameter
Description
Factory
Maintenance
Field
Firmware Version
The version number of the
firmware that is currently
loaded into the transmitter.
V
V
V
Last SWR
The Standing Wave Ratio
measured that last time a signal
was transmitted. A high
number means there might be a
problem with the feed line or
antenna. The best value is 1.
If 0, recent data are not
available.
V
V
V
Battery Voltage
The battery voltage measured
the last time a signal was
transmitted. This is not
meaningful if power is
supplied by AC voltage.
V
V
V
3.3V Supply Voltage
The measured value of the
3.3V supply. Should be within
5%.
V
V
1.8V Supply Voltage
The measured value of the
1.8V supply. Should be within
5%.
V
V
Frequency (MHz)
The frequency that is used to
transmit the alarm (must match
the frequency for the entire
alarm system). This value can
only be set at the factory or
by an authorized distributor;
proper transmission must be
confirmed after this value is
changed.
S
V
V
Transmitter Address
The numerical address of this
transmitter. See “# Addr
Digits” for more information
S
S
S
# Addr Digits
The number of digits in the
Transmitter Address (must
match the setting for the entire
system).
S
S
V