Installation Manual

Kingfisher Company, inc. STAR-ELT Manual
KCi #99420-MAN Rev 0.6 Page 9 of 29
Figure 3: Wall Mounting Detail
7.2 Recommended Procedure
1. Remove enclosure from packing and open enclosure.
2. Mount the enclosure on a wall using appropriate hardware.
3. Run all conduits necessary to the enclosure. Knockouts are provided on the sides of the
cabinet. Attach conduit to the enclosure using fittings with star locknuts. Conduits include:
power, antenna cable, and zone inputs.
4. Verify door ground wire and proper system ground connection is attached.
8. Powering Up/Down
Power-Up Procedure:
1. Connect Antenna Coax Cable to STAR-
ELT Transmitter Module.
2. Connect power wiring.
3. If using the optional power supply
Power-Down Procedure:
1. Unplug battery at battery connector.
2. Turn off AC Power at the circuit
breaker or fuse connected to the
panel.