User Manual

3
4
6
-/+ Button
The humidity level can be set within a range of 80% RH (Relative Humidity) to.
35% RH (Relative Humidity) in 5% reduce or at continuous operation.
NOTE: If Nonstop is selected, the dehumidifier will operate continuously at its
maximum dehumidification settings if attached to a hose to drain or until the
bucket is full.For drier air, press the - pad and set to a lower percent value (%).
For damper air, press the + pad and set to a higher percent value (%).
When you first use the dehumidifier, set the humidity control to 45% or 50%.
Allow at least 24 hours for the dehumidifier to achieve the humidity level. If you
still have damper air than desired, set the humidity level to a lower setting or
select Continuous for maximum dehumidification.
Display
Shows the set % humidity level while setting, then shows the actual (± 5%
accuracy) room % humidity level.
6
TIMER Button
While the dehumidifier is in operation, press this pad to set it to automatically
turn off in 2 hours or 4 hours. While the dehumidifier is off, press this pad to
set it to automatically turn on in 2 hours or 4 hours.
5
FAN SPEED Button
Controls the fan speed.
Press to select either High, Medium or Low fan speed.
Set the fan control to High for maximum moisture removal. When the humidity
has been reduced and quiet operation is preferred, set the fan control to Medium
or Low.
7
PUMP Button
Hold on pressing this button for 3s and then the unit will enter water pump
mode. Pump Mode Indicator will be on. When the water tank is full of water,
the pump will start operation and pump away the water. The pump will pump
water automatically and then stop automatically.
Attention: Pump drain hose must be well connected for this mode.