User Manual

10
Pressing + or - button once will increase or decrease set temperature by 1°F(°C).
Hold + or - button for 2s, set temperature on remote controller will change quickly.
Release the button after your required set temperature is reached.

- / + button
Under timer setting status, after each pressing of “+” or “-” button, time will
increase or decrease 0.5h or 1h. Hold “+” or “-” button, 2s later, time displayed
on dual-8 nixie tube will change quickly. Loosen the button until the time is
reached to your set time.

FAN button
This button is used for setting Fan Speed in the sequence that goes from AUTO,

I FEEL button
I feel function will be action if pressing this button. If controller receives I FEEL
order, it will work under ambient temperature value which sending by remote
controller, and remote controller will send ambient temperature value to
controller every 10min. After 11min, if controller does not receive ambient
temperature value which sending by remote controller, it will run with AC ambient
temperature; if I FEEL is not set, ambient temperature will adopt sampling
value of AC temperature sensor. If power off happens, this function will not be
memorized.
NOTE: There are 3 speeds for the Fan Speed of this model.
, , , to then back to Auto.
Auto
Speed 1 Speed 2 Speed 3
Speed 4
Each time you press the button, a mode is selected in a sequence that goes from
AUTO, COOL, SAVE, FAN and DRY, as the following:
COOLAUTO DRYFANSAVE

MODE button