User Manual

ManualsBrandsKingKong ManualsAircraftSmart 90 Super Light Carbon Fiber Micro FPV Drone (FrSky Protocol)

Instruction for RX receiver

DSM bind

Have the transmitter switched off. Hold the bind button down on the Rx then power it up (the LED of

RX should blink quickly which means it is in bind mode). Switch on your transmitter in bind mode, if

binding is successful the LED of the Rx should be on continuously.

AC800 bind (default S.BUS)

Have the transmitter switched off. Power up the Rx and wait, when the LED of the Rx starts flashing

it is in bind mode. Switch on your transmitter in bind mode, if binding is successful the LED of Rx

should on continuously.

FM800 bind (default S.BUS)

Switch on the transmitter. Hold the button of the Rx down then power on, if binding is successful the

green LED of the Rx should be on continously.

Serial Receiver Provider

SPEKTRUM1024

SPEKTRUM2048

SBUS

SUMD

Note:Remember to configure a Serial Port(via Ports tab) and choose a Serial Receiver Provider When using RX_SERIAL feature.

Receiver Mode

RX_PPM

RX_SERIAL

RX_PARALLEL_PWM

RX_MSP

PPM RX input

Serial-based receiver(SPEKSAT,SBUS,SUMD)

PWM RX input(one wire per channel)

MSP RX input(control via MSP port)

AC800 switch to PPM output

Rx output is S.BUS after binding. If you want switch to PPM then power off the transmitter, power on the

Rx and wait, when the LED of Rx

starts flashing quickly wait 30 seconds, then switch on your transmitter in

bind mode. If binding is successful the LED of Rx should stay lit up for about 10 seconds then flash 1 once.

FM800 switch S.BUS or PPM output

Switch off transmitter. Hold the button of the Rx down for 6 seconds then release (if held down to long or

not long enough it will not work). The green LED will flash quickly meaning it is in PPM output now,

flashing slowly means it is in S.BUS (click the key when green LED is flashing it will switch between PPM

and S.BUS).