Installation Guide

www.kingsbottle.com! 6
A. GENERAL INSTALLATION INSTRUCTIONS
1. This appliance is designed for both free standing and built-in (fully recessed) installation.
2. Place your wine cellar on a flat, solid floor that is strong enough to support it when it is fully loaded. To level your wine cellar, adjust
the leveling leg at the bottom of the wine cellar
3. When moving your wine cellar, please do not incline it more than 45 degrees.
4. Locate the wine cellar away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight and heat sources
may increase electrical consumption. Extreme cold ambient temperatures may also cause the unit to perform improperly.
5. Avoid locating the unit in damp areas.
6. Plug the wine cellar into an exclusive, properly installed and grounded wall outlet. Do not under any circumstances cut or remove the
third (ground) prong from the power cord. Any questions concerning power and/or electrical grounding should be directed to a
certified electrician or authorized products service center.
PART III! INSTALLATION INSTRUCTIONS
INSTALLATION
Step 1 Take out the handle from the cellar and remove the plastic bag, also remember 2pcs of screw are packed inside.
Step 3 Insert the screw through the hole and connect with the handle
Step 2! Pull out a bit of rubber gasket from the back side of the hole.
B. HANDLE INSTALLATION