USER MANUAL KBU-50 /120 /170 TWO-TEMP ZONES MODELS Note: For optimal use of this product, the temperature of the LOWER cooling zone should be set at least 4°F above the temperature of the UPPER cooling zone. For more information about the operation of this product, please refer to details in this manual COMPRESSOR WINE CELLAR www.kingsbottle.
CONTENTS CONGRATULATIONS Congratulations and thank you for choosing our KingsBottle Wine Cellars . We are sure you will find your new appliance a pleasure to use . Before you installing and operating the wine cellar, we recommend that you read through the relevant sections of this manual, which provides a description of your wine cellar and its functions .
+/2146#06 5#('6; +05647%6+105 +/2146#06 5#('6; +05647%6+105 +/2146#06 5#('6; +05647%6+105 +/2146#06 5#('6; +05647%6+105 PART I IMPORTANT SAFETY INSTRUCTIONS 0LEASE¬READ¬THE¬USER¬MANUAL¬CAREFULLY¬AND¬STORE¬IN¬A¬HANDY¬ 5#('6; 5#('6; SAFETY 4. Please read the user manual carefully and store in a handy 0LEASE¬READ¬THE¬USER¬MANUAL¬CAREFULLY¬AND¬STORE¬IN¬A¬HANDY¬ place for later reference. 0LEASE¬READ¬THE¬USER¬MANUAL¬CAREFULLY¬AND¬STORE¬IN¬A¬HANDY¬ 5. place for reference .
FEATURES PART II DIAGRAM & DESCRIPTION OF WINE CELLAR TWO-TEMP. WINE CELLAR MODELS: KBU-50, KBU-120, KBU-170 SERIES TEMP.SET TEMP.
INSTALLATION PART III INSTALLATION INSTRUCTIONS CUTOUT DIMENSION ILLUSTRATED KBU-170 SERIES 23.54”W x 26.97”D x 71.69”H (598W x 685D x 1821H mm) Included stand height 0.98”(25mm) KBU-120 SERIES 23.54”W x 26.97”D x 55.43”H (598W x 685D x 1408H mm) Included stand height 0.98”(25mm) MODEL WIDTH DEPTH HEIGHT INCLUDED STAND HEIGHT KBU-170S 23.54” 598mm 26.97” 685mm 71.69” 1821mm 0.98” 25mm KBU-120S 23.54” 598mm 26.97” 685mm 55.43” 1408mm 0.98” 25mm KBU-50S 23.42” 595mm 23.62” 600mm 33.
INSTALLATION PART III INSTALLATION INSTRUCTIONS A. GENERAL INSTALLATION INSTRUCTIONS 1. This appliance is designed for both free standing and built-in (fully recessed) installation. 2. Place your wine cellar on a flat, solid floor that is strong enough to support it when it is fully loaded. To level your wine cellar, adjust the leveling leg at the bottom of the wine cellar 3. When moving your wine cellar, please do not incline it more than 45 degrees. 4.
INSTALLATION PART III INSTALLATION INSTRUCTIONS C. INSTALLATION OF FRONT GRILL D. INSTALLATION OF BUILT-IN CELLAR (MINIMUM CAVITY SPACE REQUIRED) The cutout dimension illustrated in figure (D) allows for door swing and access to the pull-out shelves when installed as a built-in appliance. If installing between frameless cabinets, a 1⁄2” wide filler strip or side panel may be needed on hinge side. The filler strip will act as a spacer between the appliance case and adjacent cabinet door swing.
INSTALLATION PART III INSTALLATION INSTRUCTIONS E. REVERSING THE DOOR SWING OF YOUR APPLIANCE • The unit is delivered to you with the door opening from the left side (hinge on right side) • The door of this appliance is capable of opening from either the left or right side.
INSTALLATION PART III INSTALLATION INSTRUCTIONS INSTRUCTION OF REVERSING DOOR FOR KBU-50 SERIES WARNING • Before you begin to reverse the door, it is recommended to tape down shelves to avoid movement during the process • It is recommended to take out the wine bottles from the cellar before reversing the door COMPRESSOR WINE CELLAR www.kingsbottle.
INSTALLATION PART III INSTALLATION INSTRUCTIONS F. INSTALLING YOUR WINE COOLER 1. Move the appliance into its final position . 2. If the appliance is not tilting back as described earlier, minor adjustments can be made to the leveling legs. 3. Compare the alignment of the appliance to the surrounding cupboard . The top of the appliance should be level from side to side (see diagram below) . 4. If the appliance now rocks from one corner to the opposite rear corner, this means that the floor is uneven.
OPERATION PART IV OPERATING YOUR WINE CELLAR TEMP.SET LOCK ON/OFF ON/OFF TEMP.SET RED WHITE TEMP. SET UPPER ZONE LOWER UPPER TEMP. SET SPARKLE LOWER ZONE Each wine cellar includes an operating panel on the front of the unit. This operating panel includes several features to operate and control the temperature of both the upper and lower zones of the wine cellar. The operating panel includes the following features: ON/OFF: Turns the wine cellar power on or off. TEMP.
STORAGE PART VI LAYOUT AND STORAGE YOUR CABINET WAS DESIGNED TO STORE A MAXIMUM NUMBER OF BOTTLES SECURELY. WE RECOMMEND THAT YOU OBSERVE THE TIPS BELOW TO OPTIMIZE LOADING. 1. Disperse your bottles even so as not to concentrate weight in any one area, Also, be careful that your bottles do not touch either the back of the cabinet or the step at the bottom. 2. Also make sure that bottles are not all grouped together either at the top or bottom of the cabinet. 3.
REMOVING SHELF PART VII REMOVING THE ROLLING SHELF 5#('6; TO REMOVE A ROLLING SHELF: 1. Remove all bottles 2. Pull the shelf out as far as possible 3. Push the LEFT side lever downward but RIGHT side lever upward (as illustrated below) 4. Remove the shelf +/2146#06 5#('6; +05647%6+105 WARNING The refrigerator must be plugged into its own dedicated 220-240V, 50Hz AC electrical outlet. The plug must be accessible when the refrigerator is place for later reference. in position.
TROUBLESHOOTING PART IX TROUBLESHOOTING GUIDE Many common issues with your wine cellar can be solved very easily, Try the tips below to troubleshoot your wine cellar should you experience any problems. Code Description Solution E1 When the temp. in UPPER zone is 4F (2C degree) higher than LOWER zone, E1 display on panel. With the temp. changes, temp. in UPPER zone is lower than LOWER zone, E1 will disappear automatically. So, just wait for about one hour and check again. F1 1.
TROUBLESHOOTING PART IX TROUBLESHOOTING GUIDE PROBLEM Wine Cooler does not operate POSSIBLE CAUSE Solution 1. Not plugged in 2. The appliance is turned OFF 3. The circuit breaker tripped or a fuse has blown out 4.
TECHNICAL DATA PART X TECHNICAL DATA MODEL NO.
NOTES COMPRESSOR WINE CELLAR www.kingsbottle.
NOTES www.kingsbottle.
NOTES COMPRESSOR WINE CELLAR www.kingsbottle.
WARRANTY PART XI WARRANTY INFORMATION Please speak to your Retailer before calling BTO AMERICA LIMITED if you did not purchase your Wine Cellar directly from BTO AMERICA LIMITED Limited warranty – 90 day replacement plan with a free 9 months upgrade, totaling 1 year, on parts and labor from the date of shipment. For customer service, please contact BTO AMERICA LIMITED by e-mail ( service@kingsbottle.com) .
