Installation & Assembly

Last Updated: 2/22/19 1
Decal Application Instructions
1.
Measure where you want your decal to be. Then tape in place
on 1 side only to use as a hinge, using regular masking tape.
Place your tape on the top, bottom or either side, however you
feel more comfortable.
2. Peel the bottom WAXY LINER layer away from the DECAL and
MASK LAYER starting at the opposite side of the masking taped
hinge, and slowly remove it.
3. Wet method is suggested for beginners and larger decals. To
use the wet method placement, spray the smooth surface with a
mixture of soap and water.
Wet Application Fluid:
Wet method is how you install larger
images with NO BUBBLES in it, being wet allow
s you
to squeegee
out the air bubbles trapped inside
and gives you the opportunity
to remove or reposition the decal if it needs to be adjusted
before it sticks to the surface. You can make your own application
fluid with 4 drops of dishwashing liquid (dawn, joy, or baby
shampoo etc.) to 1 quart of water in a spray bottle.
4. While still holding the PRE-MASK layer away from the smooth
surface. Use a squeegee, credit card or any plastic straight edge
to help in application. Start from the side with the tape and
gently work away from the tape and squeegee out all water and
soap.
(
Note: if you do not have a squeegee use your fing
ertips or
the sharp edge of a credit card, plastic ruler or similar
object)
5. Use your squeegee and apply pressure from the middle to the
outward sides, this will remove all water and start the decal
adhesion. Let sit for 5 minutes before removing. If your decal
appears to not be sticking the fluid is still behind the decal, just
s
queegee again and let sit for 10-15 minutes.
The decals have a pressure sensitive adhesive the harder
you rub the harder it sticks, also the longer you let it sit
the stronger the adhesive will adhere.