ook N~ KINGSTON KITCHEN & BATH INSTALLATION INSTRUCTIONS Angle Stop Instructions: Apply thread sealant tape to threads (1). Screw valve body (2) onto pipe (3). Place nut (4) and ring (5) on tube (6). Insert tube (6) into valve. Wrench tighten nut (4) onto valve. Stop any leaks by tightening nuts slightly. www.kingstonbrass.
KINGSTON Kitchen & BATH INSTALLATION INSTRUCTIONS Decorative P-Trap Instructions: Remove horizontal leg and slip joint nut from bottle trap. Apply Teflon tape to all exposed threads. Insert slip joint nut (3) and waste cover (4) onto horizontal leg (6). Insert horizontal leg into wall waste opening, do not tighten. Insert black washer (2) and slip joint nut (1) onto tail piece (8). Attach bottle trap (7) to tail piece and hand tighten slip joint nut (1).
KINGSTON HEMOSTAT & BATH www laughingstock TOLL-FREE CUSTOMER SERVICE: 1-877-2-BRASS TECHNICAL SUPPORT E-mail: 12775 Reservoir Street, Chino, CA 91710
KINGSTON HERIBERTO R B INSTALLATION INSTRUCTIONS Push Drain with or without Overflow Basin Wrench Adjustable Wrench Teflon Tape Silicone Sealant Screwdriver INSTALLATION: 1. Remove the lock nut (7), washer {6) and rubber gasket (5} from the drain body (3). 2. Insert the drain assembly downward through the drain opening on the bottom of sink. So the tailpiece (8) and the outer threads of drain body (3) can go all the way through the drain opening and expose beneath the sink. 3.
P-Trap Installation: 9 4. Wales Cover 8. Tail Piece 8. Horizontal Leg 1. lip Joint Nut 2. Black Washer 7. Boyle Trap 3. Slip Joint Nut 5. Black Washer 1. Remove horizontal leg and slip joint nut from bot fie trap. 2. Apply tension to all exposed threads. 3. Insert slip joint nut{3) and waste onto horizontal leg(8). 4. Insert horizontal |ag into wall waste opening, do not tighten. 5. Insert black washer(2) and slip joint tail piece(8). 6.
FAUCET INSTALLATION INSTRUCTIONS For Use Vessel Sink Before Installation : 1. Pricr the installation, unpack your new Kingston Brass product and inspect it keep the product in its original package until you are ready to install it. 2.Shut the water supply off when replacing an existing fixture. Preparation of the soars and walls, including all additional wall supports, maybe required. observer all local plumbing and building codes. 4.Do not install this fixture alone. 5.