0 YEAR MANUFACTURER'S LIMITED WARRANTY Al parts of this Kingston Brass faucet are warranted to the original retail purchaser to be free from defects in material and workmanship for a period of Ten(10) years from the date of purchase as shown on the purchaser’s receipt. This warranty is limited to defective parts only, labor charges and/or damage resulting from improper installation, repair or replacements, as well as incidental and consequential damages connected therewith are excluded.
s INSTALLATION INSTRUCTIONS For Use With KB's Wall Mount Tub Filler With Hand Shower INNING || | 1. Flush plumbing lines to clear any debris. 2. Shut off both supply lines after flushing. Need Tools: M%% == Basin Wrench Adjustable Wrench Teflon Tape Silicone Sealant ~ Screwdriver 1 E Apply Teflon tape 1. Shut off hot and cold water supply under sink. Plug sink drain with cloth to avoid losing small parts. Remove old faucet 2. Apply Teflon tape on the threads of the copper shank. Install the slow.
KINGSTON BRASS THE TRADITION OF FINE BRASS INSTALLATION INSTRUCTIONS For Use With KB's Shower Riser Bath Supply BEFORE BEGINNING INSTALLATION: 1. Flush plumbing lines to clear debris in pipe and plumbing lines to avoid existing clogs into waterway & cartridge system of new faucet fixture. 2. Shut off both supply lines after flushing Anchor Wall Support Bracket § Riser Wall Support g (73— Shower Ring Connector RN fi ' Take out the anchor \ \ // Use Teflon Tape N / Couplet @b Ceiling Support Bracket Mounting S
Installation manual for hand shower Put a washer to the cone shape hose nut and hand tightens the hand shower clockwise. installation manual for pull-out & pull-down spar 2. Tum on the water and check for leaks, if the han shower leaks at the connection to the hose, hand tighten the connection some mots. Thread has to spray head and feed from the top into the faucet spout, tum tha spout to the right or to the left fully to facilitate the insertion of the hose. 2.
KINGSTON BRASS A e INSTALLATION INSTRUCTIONS = For Use With KB's Hand Shower Sets, Shower head Sets Basin Wrench Adjustable Wrench Teflon Tape Silicone Sealant and Kitchen Sprayer @fi@ Ba fore installation: Feeble Wal fi Hold the existing shower arm up and down to ensure the plumbing behind the wall is exile Enervate rigid to hold the weight of the new shower unit about 3-4 lbs when filed with water.
Single Offset Bath Supply Installation Parts: Can Washer & | Cone Washer & Coupling Nut& | Coupling Nut & Escutcheon Friction Ring Friction Ring (34" IPS) (' IPs) PCs PCs PCs www.kingstonbrass.
KINGSTON BRAS, /s THE TRADITION OF FINE BARBS www.kingstonbrass.
KINGSTON BRAS THE TRADITION OF FINE BRASS INSTALLATION INSTRUCTIONS For Use With KB's Brass Claw foot Tub Bath Drain Note:1. Observe all local plumbing and building codes. TOOLS REQUIRED Drain Wrench Adjustable Wrench Teflon Tape Silicone Sealant Screwdriver Pipe Wrench INSTALLATION INSTRUCTIONS 1.Place rubber washer (10) onto waste tube (9) and set them under the tub. 2.