0 YEAR MANUFACTURER'S LIMITED WARRANTY Al parts of this Kingston Brass faucet are warranted to the original retail purchaser to be fees from defects in material and workmanship for a period of Ten(10) years from the date of purchase as shown on the purchaser's receipt This warranty is limited to defective parts only, labor charges and/or damage resulting from improper installation, repair or replacements, as well as incidental and consequential damages connected therewith are excluded.
For Use With KB's Wall Mount Exposed Shower BEFORE BEGINNING INSTALLATION 1. Flush plumbing lines to clear any debris. 2. Shut off bath supply lines after flushing. Need Tools: Fef) =3 Basin Wrench Adjustable Wrench o [y, = Teflon Tape Silicone Sealant Screwdriver Shut off main water supply valve before installation. 2. Turn on old faucet fo remove any excess water in the supply lines. Apply Teflon tape onto both threads of supply elbows. 5.
Replacement Parts: Parts: Cartridge: KS1000H Ca old Handle: KSHATRIYA \ CARE AND MAINTENANCE OF YOUR FAUCET Your Kingston Brass faucet has been finished to the most strict standards; however, due to the high content of minerals in the water, your finish may appear dull and famished after time. These are some do's and don'ts to maintain the luster on your faucet for many years to come. Do 1. Use a silicon based caulking when installing. 2. Clean your faucet with only a mild soap and water solution 3.
Installation manual for hand shower Put a washer lo the cone shape hose nut and hand titans the hand shower clockwise. 2. Turn on the water and check for leaks, If the hand shower leaks at the connection to tha hos, hand Ugh ten the inaction some mots. Installation manual for pull-out & pull-down sprayer. 1] 3 0 (2] 1. Thread hose to spray head and fade from the lop Ina e faucet spout, tum the spout to the right or to the left fully to facilitate the insertion of the hose. 2.
INSTALLATION INSTRUCTIONS For Use With KB's Han Shower Sets, Shower head Sets Basin Wrench Adjustable Wrench Teflon Tape Silicone Sealant and Kitchen Sprayer fi Before installation: % Flexibly Watt Hold the existing shower arm up and down to ensure Ihe plumbing behind the wall is Pipe Wrench Screwdriver d Plumber's Putty rigid lo half the wait of the new shower unit about 3-4 |bs when filled with water. Installation manual for shower arm & shower head: Place tha fang lino the shower rod.
KING! DN DA THE TRADITION OF FINE BRASS Installation Instructions For Use With KB's Concerto Shower without Spout BEFORE BEGINNING INSTALLATION 1. Flush plumbing lines to clear debris in pipe and plumbing lines to avoid existing clogs info waterway & cartridge system of new faucet fixture. 2. Shut off both supply lines after gushing Inch SN Wall Support Bracket ~ PP Mounting Screw <= Use Teflon Tape Use Teflon Tape Mounting Screw x & Anchor s < Use Teflon Tape PCs www.kingstonbrass.