0 YEAR MANUFACTURER'S LIMITED WARRANTY Al parts of this Kingston Brass faucet are warranted to the original retail purchaser to be fees from defects in material and workmanship for a period of Ten(10) years from the date of purchase as shown on the purchaser's receipt This warranty is limited to defective parts only, labor charges and/or damage resulting from improper installation, repair or replacements, as well as incidental and consequential damages connected therewith are excluded.
Need Tools: KIN, INSTALLATION INSTRUCTIONS —p &= For Use With KB's Wall Mount Tub Filler With Hand Shower Basin Wrench Adjustable Wrench Teflon Tape Silicone Sealant Screwdriver BEFORE BEGINNING INSTALLATION 1. Flush plumbing lines to clear any debris. 2. Shut off both supply lines after gushing. Apply Teflon tape 8. Place a washer between the side hole of the shower cradle and the cons nut of the shower hos. Tighten the cone nut. 1. Shut off main water supply valve before installation. 2.
KINGSTON BRASS THE TRADITION OF FINE BRASS INSTALLATION INSTRUCTIONS For Use With KB's Shower Riser Bath Supply BEFORE BEGINNING INSTALLATION: 1. Flush plumbing lines to clear debris in pipe and plumbing lines to avoid existing clogs into waterway & cartridge system of new faucet fixture. 2. Shut off both supply lines after flushing Anchor Wall Support Bracket § Riser Wall Support g (73— Shower Ring Connector RN fi ' Take out the anchor \ \ // Use Teflon Tape N / Couplet @b Ceiling Support Bracket Mounting S
Installation manual for hand shower Put a washer lo the cone shape hose nut and hand titans the hand shower clockwise. 2. Turn on the water and check for leaks, If the hand shower leaks at the connection to tha hos, hand Ugh ten the inaction some mots. Installation manual for pull-out & pull-down sprayer. 1] 3 0 (2] 1. Thread hose to spray head and fade from the lop Ina e faucet spout, tum the spout to the right or to the left fully to facilitate the insertion of the hose. 2.
INSTALLATION INSTRUCTIONS For Use With KB's Han Shower Sets, Shower head Sets Basin Wrench Adjustable Wrench Teflon Tape Silicone Sealant and Kitchen Sprayer fi Before installation: % Flexibly Watt Hold the existing shower arm up and down to ensure Ihe plumbing behind the wall is Pipe Wrench Screwdriver d Plumber's Putty rigid lo half the wait of the new shower unit about 3-4 |bs when filled with water. Installation manual for shower arm & shower head: Place tha fang lino the shower rod.
Single Offset Bath Supply Installation Parts: Can Washer & | Cone Washer & Coupling Nut& | Coupling Nut & Escutcheon Friction Ring Friction Ring (34" IPS) (' IPs) PCs PCs PCs www.kingstonbrass.
KINGSTON BRAS, /s THE TRADITION OF FINE BARBS www.kingstonbrass.
KINGSTON BRAS THE TRADITION OF FINE BRASS INSTALLATION INSTRUCTIONS For Use With KB's Brass Claw foot Tub Bath Drain Note:1. Observe all local plumbing and building codes. TOOLS REQUIRED Drain Wrench Adjustable Wrench Teflon Tape Silicone Sealant Screwdriver Pipe Wrench INSTALLATION INSTRUCTIONS 1.Place rubber washer (10) onto waste tube (9) and set them under the tub. 2.