0 YEAR MANUFACTURER'S LIMITED WARRANTY Al parts of this Kingston Brass faucet are warranted to the original retail purchaser to be fees from defects in material and workmanship for a period of Ten(10) years from the date of purchase as shown on the purchaser's receipt This warranty is limited to defective parts only, labor charges and/or damage resulting from improper installation, repair or replacements, as well as incidental and consequential damages connected therewith are excluded.
] i 1 INSTALLATION INSTRUCTIONS For Use With KB's Wall Mount Tub Filler With Hand Shower BEFORE BEGINNING INSTALLATION 1. Flush plumbing lines to clear any debris. 2. Shut off both supply lines after flushing Need Tools: b Basin Ranch Adjustable Ranch G [, e Teflon Tape Silicons Sealant Screwdriver ] 2] Apply Teflon pale B 2. Apply Teflon tape on the threads of the copper shank. [stall the elbow. ยง. Claps a washer between the side hale of the shower cradle and the cone nut of the shower hose.
Single Offset Bath Supply Installation Parts: Can Washer & | Cone Washer & Coupling Nut& | Coupling Nut & Escutcheon Friction Ring Friction Ring (34" IPS) (' IPs) PCs PCs PCs www.kingstonbrass.
KINGSTON BRAS, /s THE TRADITION OF FINE BARBS www.kingstonbrass.
KINGSTON BRAS THE TRADITION OF FINE BRASS INSTALLATION INSTRUCTIONS For Use With KB's Brass Claw foot Tub Bath Drain Note:1. Observe all local plumbing and building codes. TOOLS REQUIRED Drain Wrench Adjustable Wrench Teflon Tape Silicone Sealant Screwdriver Pipe Wrench INSTALLATION INSTRUCTIONS 1.Place rubber washer (10) onto waste tube (9) and set them under the tub. 2.
KINGSTON THE TRADITION OF WINE BRASS Installation Instructions For Use With KB's Straight Stop Instructions: 1. Apply thread sealant tape to threads (1). 2. Screw valve body (2) onto pipe (3). 3. Place nut (4), metal washer (5) and rubber washer (6) on tube (7). 4. Insert tube (7) into valve. 5. Wrench tighten nut (4) onto valve. 6. Stop any leaks by tightening nuts slightly. www. Kingstonbrass.