P-Trap Installation: & se 4, Waste Cover 6. Horizontal Leg 1. Slip Joint Nut 2 Black Washer 3. Slip Joint Nut . Bl 7. Bottle Trap 5. Black Washer Remove horizontal leg and slip joint nut from bottle trap. Apply Teflon tape to all exposed threads. Insert slip joint nut (3) and waste cover {4) onto horizontal leg (6). Insert horizontal leg into wall waste opening, do not tighten. Insert black washer (2) and slip joint nut (1)onto tail piece (8).
FAUCET INSTALLATION INSTRUCTIONS Semi-Recessed Sink Before Installation : 1. Prior the installation, unpack your new Kingston Brass product and inspect it keep the product in its original package until you are ready to install it. Shut the water supply off when replacing an existing fixture. Preparation of the floors and walls, including all additional wall supports, maybe required. Observe all local plumbing and building codes. Do not install this fixture alone.
KINGSTON KITCHEN & BATH Toggle Bolt Anchor Installation Instructions: 1. 2. If you are installing on a plaster (Drywall) wall we recommend using toggle bolt anchors (included), drill a 5/8” hole at the marked location of the holes Remove toggle from bolt, insert washer on the bolt and insert bolt through the basin mounting holes.