P-Trap Installation: 9 4. Waste Cover 8. Tail Piece 6. Horizontal Leg 1. Slip Joint Nut 2. Black Washer 7. Bottle Trap 3. Slip Joint Nut 5. Black Washer 1. Remove horizontal leg and slip joint nut from bottle trap. 2. Apply Teflon to all exposed threads. 3. Insert slip joint nut(3) and waste cover(4) onto horizontal leg(6). 4. Insert horizontal leg into wall waste opening, do not tighten. 5. Insert black washer{2) and slip joint tail piece(8). 6.
FAUCET INSTALLATION INSTRUCTIONS For Use Vessel Sink Before Installation : 1.Prior the installation, unpack your new Kingston Brass product and inspect it keep the product in its original package until you are ready fo install it. 2.Shut the water supply off when replacing an existing fixture. Preparation of the floors and walls, including all additional wall supports, maybe required. observer all local plumbing and building codes. 4.Do not install this fixture alone. 5.
10 YEAR MANUFACTURER'S LIMITED WARRANTY All parts of this Kingston Brass faucet are warranted to the original retail purchaser to be free from defects in material and workmanship for a period of Ten(10) years from the date of purchase as shown on the purchaser's receipt This warranty is limited to deflective parts only, labor charges and/or damage resulting from improper installation, repair or replacements, as well as incidental and consequential damages connected therewith are excluded.
0 ji INSTALLATION INSTRUCTIONS For Use With KB's Single Handle Vessel Sink Faucet BEFORE BEGINNING INSTALLATION 1. Flush plumbing lines Io clear any debris. 2. Shut off both supply lines after flushing. 1 1 Pld 1. Shut off hot and cold water supply under sink. Plug sink drain with cloth to avid losing small parts. Remove old faucet. 2. Inset the ballpoint the faucet body.
Parts: Replacement Parts: Cartridge: KSRP3831C — Handle: KSHATRIYA CARE AND MAINTENANCE OF YOUR FAUCET Your Kingston Brass faucet has been finished to the most strict standards; however, due tn the high content of minerals in the water, your finish may appear dull and famished after time. These are some do's and don'ls to maintain the luster on your faucet for many years ta come. Do 1. Use a silicon based caulking when installing. 2 Clean your faucet with only a mild soap and water solution 3.
Kl OVARY, ERE ee www.kingstonbrass.
iY Eee ty SEs ase INSTALLATION INSTRUCTIONS For Use With KB's Push Drain without Overflow Need Tools: Basin Wrench ~~ Adjustable Wrench Teflon Tape Silicone Sealant ~~ Screwdriver INSTALLATION: 1. Remove the lockout, washer(6) and rubber gasket{5) from the drain body(3). 2. Insert the drain downward through the drain opening on the bottom of sink. So the tailpiece(8) and the outer threads of drain body(3) can go all the way through the drain opening and expose beneath the sink. 3.