0 YEAR MANUFACTURER'S LIMITED WARRANTY All parts of this Kingston Brass faucet are warranted to the original retail purchaser to be free from defects in material and workmanship for a period of Ten(10) years from the date of purchase as shown on the purchaser's receipt. This warranty is limited to defective parts only, labor charges and/or damage resulting from improper installation, repair or replacements, as well as incidental and consequential damages connected therewith are excluded.
KINGSTON KH ATH Need Tools: I Ix 4. While holding from under the sink install tim ring and thread escutcheon on to stem assembly, adjust to a suitable height to allow sufficient space for handle to operate smoothly. Tighten bottom nut, please make sure to align direction of lever handles before tightening stem. 5. Apply Teflon tape on all male threading and install inlet supply lines {not included) to bottom inlet port of hot and cold valve assembly. Warning!!! ยป Do not aver-tighten nut during installation.
Replacement Parts: Hot Cartridge: FSCRP1971HC. Cold Cartridge FSCRP1S71CC Cold Handle: KBH8861ZXC CARE AND MAINTENANCE OF YOUR FAUCET Your Kingston Brass faucet has been finished to the most strict standards, however, due to the high content of minerals in the water, your finish may appear dull and famished after time. ese are some do's and don'ts to maintain the luster on your faucet for many years to come. DO 1. Use a silicon based caulking when installing. 2.
KINGSTON KITCHEN RB BATH Mounting nut installation instructions To install the mounting hardware: 1 1. Unscrew Both adjustment screws as much as possible without removing them. 2 2. Thread lock nut onto the valve assembly and slip on the metal washer. 3 3. Once the valve assembly has been secured from the top, 4 hand tighten brass lock nut all the way to the top. Tight the 5 nut to flush with steel washer and secure the valve by hand. 4.