0 YEAR MANUFACTURER'S LIMITED WARRANTY All parts of this Kingston Brass faucet are warranted to the original retail purchaser to be free from defects in material and workmanship for a period of Ten(10) years from the date of purchase as shown on the purchaser's receipt This warranty is limited to defective parts only, labor charges candor damage resulting from improper installation, repair or replacements, as well as incidental and consequential damages connected therewith are excluded.
iis INSTALLATION INSTRUCTIONS For Use With KB's Twin Handles Lavatory Faucet with or without Pop-Up BEFORE BEGINNING INSTALLATION 1. Flush plumbing lines to clear any debris. 2. Shut off both supply lines after flushing. [1] 1. Shut off hot and cold walrus supply under sink. Plug sink drain with cloth to avoid losing small parts. Remove old faucet 2. Insert the inlet shanks through the sink holes, and press down.
Replacement Parts: 8 Cartridge: KBRF101C ye Hot Handle: KBHBO01ALH Eo Cold Handle: KEHE01 ALC Parts: J CARE AND MAINTENANCE OF YOUR FAUCET Your Kingston Brass faucet has been finished to the most strict standards; however, due tn the high content of minerals in the water, your finish may appear dull and famished after time. These are some do's and don'ls to maintain the luster on your faucet for many years ta come. Do 1. Use a silicon based caulking when installing.
TOOLS REQUIRED Se Flathead Screwdriver Sa Phillips Screwdriver ~N Marking Pencil Rs Hammer u Power Drill Towel Bar Installation =I Sp EE FINE BRA Parts: Installation Steps: Mounting | ood Sat Step 1. Locate where you would like to install the towel bar. Mounting Plate Loren Screw Place a base onto the wall and trace around it with a pencil (fig 1). Step 2. Unscrew the slotted set screw of the base and remove the mounting plate. Step 3.
EEE Towel Ring Installation Parts: Mounting Plate Hun Slated Sat & Anchor crew Sy Il J 1Pc PCs 1Pc www laughingstock TOLL-FREE CUSTOMER SERVICE: 1-877-2-BRASS TECHNICAL SUPPORT E-mail: 12775 Reservoir Street, Chino, CA91710 a N TOOLS REQUIRED Se Flathead Screwdriver Se Phillips Screwdriver ~N Marking Pencil Rs Hammer u Power Drill Installation Steps: Step 1. Locate where you would like to install the towel ring. Place a base onto the wall and trace around it with a pencil (fig 1). Step 2.
FINE BRA Robe Hook Installation Parts: Mounting Plate Hun Slated Sat & Anchor crew 1Pc PCs 1Pc www laughingstock TOLL-FREE CUSTOMER SERVICE: 1-877-2-BRASS TECHNICAL SUPPORT E-mail: 12775 Reservoir Street, Chino, CA91710 TOOLS REQUIRED Se Flathead Screwdriver Se Phillips Screwdriver ~N Marking Pencil Rs Hammer u Power Drill Installation Steps: Step 1. Locate where you would like to install the robe hook. Place a base onto the wall and trace around it with a pencil (fig 1). Step 2.
FINE BRA Toilet Paper Holder Installation Parts: Mounting Mounting Plats| Screw Slotted Sat & Anchor crew PCs PCs PCs www laughingstock TOLL-FREE CUSTOMER SERVICE: 1-877-2-BRASS TECHNICAL SUPPORT E-mail: 12775 Reservoir Street, Chino, CA91710 TOOLS REQUIRED Se Flathead Screwdriver Sa Phillips Screwdriver ~N Marking Pencil Rs Hammer u Power Drill Fig. 4 Installation Steps: Step 1. Locate where you would like fo install the toilet paper holder.