e Cast Iron Bath Tub Installation Parts: Washer Bolts & Lockout Pcs PCs www.kingstonbrass.com TOLL-FREE CUSTOMER SERVICE: 1-877-2-BRASS TECHNICAL SUPPORT E-mail: 12775 Reservoir Street, Chino, CA91710 TOOLS REQUIRED =7 R Adjustable Wrench Rubber Mallet [I Mark location Installation Steps: Step 1. Turn tub over and set on non-abrasive mat, insert pyramid bolts unto the mounting slot at the bottom of the tub. Step 2.
10 YEAR MANUFACTURER'S K ] N LIMITED WARRANTY . Al parts of this Kingston Brass faucet are warranted to the original retail purchaser to be fees from defects in material and workmanship for a period of Ten(10) years from the date of purchase as shown on the purchaser's receipt This warranty is limited to defective parts only, labor charges and/or damage resulting from improper installation, repair or replacements, as well as incidental and consequential damages connected therewith are excluded.
Need Tools: INSTALLATION INSTRUCTIONS D = For Use With KB's Wall Mount Tub Filler F=f % e Basin Wrench Adjustable Wrench Teflon Tape Silicone Sealant Screwdriver BEFORE BEGINNING INSTALLATION 1. Flush plumbing lines to clear any debris. 2. Shut off bath supply lines after flushing. 1 2] 1. Shut off man wale supply valve before Installation 2. Install the spout on top of faucet body. 5. Connect water supply shank to hot and cold water 6. Turn on wale supply valves and sack for Umiaks, supply line.
Replacement Parts: Parts: Hot Cartridge KSRPT1000HC ((G= Cold Cartridge: KSRPT1000CC % Shorthand: CCMX1H % Cold Handle: CCMX1C . J CARE AND MAINTENANCE OF YOUR FAUCET Your Kingston Brass faucet has been finished to the most strict standards; however, due tn the high content of minerals in the water, your finish may appear dull and famished after time. These are some do's and don'ls to maintain the luster on your faucet for many years ta come. Do 1. Use a silicon based caulking when installing.
KINGSTON BRAS, /s THE TRADITION OF FINE BARBS www.kingstonbrass.
KINGSTON BRAS THE TRADITION OF FINE BRASS INSTALLATION INSTRUCTIONS For Use With KB's Brass Claw foot Tub Bath Drain Note:1. Observe all local plumbing and building codes. TOOLS REQUIRED Drain Wrench Adjustable Wrench Teflon Tape Silicone Sealant Screwdriver Pipe Wrench INSTALLATION INSTRUCTIONS 1.Place rubber washer (10) onto waste tube (9) and set them under the tub. 2.
Single Offset Bath Supply Installation Parts: Can Washer & | Cone Washer & Coupling Nut& | Coupling Nut & Escutcheon Friction Ring Friction Ring (34" IPS) (' IPs) PCs PCs PCs www.kingstonbrass.