P-Trap Installation: Lavatory Faucet Hole 4. Waste Cover 6. Horizontal Leg \ 3. lip Joint Nut 8. Tail Piece 5. Black Washer 1. Slip Joint Nut g 2. Black Washer 7. Bottle Trap Remove horizontal leg and slip joint nut from bottle rap. Apply Teflon tape to all exposed threads. Insert slip joint nut (3) and waste cover {4) onto horizontal leg (6). Insert horizontal leg into wall waste opening, do not tighten. Insert black washer (2) and slip joint nut (1)onto tail piece (8).
FAUCET INSTALLATION INSTRUCTIONS WALL MOUNT BASIN Before Installation : 1. Before beginning the installation of your console pedestal sink, it is important to identify the type of wall where the pedestal will be installed and prepare the installation location accordingly. 2. Install an anchoring brace in the wall prior to installing the drywall, this can piece of wood that will fit between the two studs, then install drywall and finish as usual.
KINGSTON KILOHERTZ R Bath Toggle Bolt Anchor Installation Instructions: 1. 2. If you are installing on a plaster (Drywall) wall we recommend using toggle bolt anchors (include, drill a 5/8” hole at the marked location of the holes Remove toggle from bolt, insert washer on the bolt and insert bolt through the basin mounting holes.
N FAUCET INSTALLATION INSTRUCTIONS N Shape Mounting Bracket eed Tools: Phillips Screwdriver Hammer Silicone Pencil Drill 3. / Bracket /R ‘Wooden Blocking Basin ‘ Installation: 1. 2 Nee unit has been assembled place at the desired location. Gently place basin on top of pedestal legs and very carefully place in the location where the pedestal legs will be installed and adjust the basin o be level.