P-Trap Installation: Lavatory Faucet Hole 4. Waste Cover 8. Tail Piece 6. Horizontal Leg 1. Slip Joint Nut — 3. Slip Joint Nut 2. Black Washer 5. Black Washer 7. Bottle Trap J Remove horizontal leg and slip joint nut from bottle trap. Apply Teflon tape to all exposed threads. Insert slip joint nut {3) and waste cover (4) onto horizontal leg (6). Insert horizontal leg into wall waste opening, do not tighten. Insert black washer (2) and slip joint nut {1)onto tail piece (8).
FAUCET INSTALLATION INSTRUCTIONS Vanity Tops and Console Sink Before Installation : 1 aw Prior the installation, unpack your new Kingston Brass product and inspect it keep the product in its original package until you are ready to install it. Shut the water supply off when replacing an existing fixture. Preparation of the floors and walls, including all additional wall supports, maybe required. Observe all local plumbing and building codes. Do not install this fixture alone.
KINGSTON KITCHEN BATH Steel Bathroom Console Sink Base With Glass Shelf Installation Installation Steps: Parts: o Shape Straight Tubs 1Pc 1Pc PCs = Screw Bolt Gasket | Glass Sheaf | Mounting Bracket [H] 225mm | [1k comm | J [1 x750m| waa 1Pc 1Pg PCs | PCs | PCs | apes 1Pc poss www laughingstock TOLL-FREE CUSTOMER SERVICE: 1-877-2-BRASS TECHNICAL SUPPORT E-mail: 12775 Reservoir Street, Chino, CA 91710 TOOLS REQUIRED Allen Wrench Tay, Phillips Screwdriver Marking Pencil Hammer “1 Power Dri — Cc Step 1.
FAUCET INSTALLATION INSTRUCTIONS L Shape Mounting Bracket Need Tools: Phillips Screwdriver Hammer Silicone Pencil Drill Note: If the basin is going to be installed on console base which has 4 legs standing on floor, the bracket could be optional. Installation: 1. Once unit has been assembled place at the desired location. 2.