0 YEAR MANUFACTURER'S LIMITED WARRANTY Al parts of this Kingston Brass faucet are warranted to the original retail purchaser to be fees from defects in material and workmanship for a period of Ten(10) years from the date of purchase as shown on the purchaser's receipt This warranty is limited to defective parts only, labor charges and/or damage resulting farm improper installation, repair or replacements, as well as incidental and consequential damages connected therewith are excluded.
Need Tools: Pl = G INSTALLATION INSTRUCTIONS For Use With KB's Widespread Lavatory Faucet Basin Wrench Charitableness Fontanel Silicone Sealant Screwdriver with or without Pop-Up BEFORE BEGINNING INSTALLATION 1. Flush both supply lines ta clear any debris. 2. Shut off both supply lines after flushing Drain Plug Sink Drain Flange Opening Mounting Nut Pivot Rod Opening 7. Apply silicons o bottom side of flange.
Replacement Parts: Go~ @ Hat Cartridge FSCRP1971HC 2 | Cold Cartridge FSCRP1S71CC Cu old Handle: KBHB981DXC CARE AND MAINTENANCE OF YOUR FAUCET Your Kingston Brass faucet has been finished to the most strict standards; however, due to the high content of minerals in the water, your finish may appear dull and famished after time. These are some do's and don'ts to maintain the luster on your faucet for many years to come. Do 1. Use a silicon based caulking when installing.
Mounting nut installation instr To install the mounting hardware: 1. Unscrew Both adjustment screws as much as possible without removing them. 2. Thread lockout onto the valve assembly and slip on the metal washer. 3. Once the valve assembly has been secured from the top, hand tighten brass Knockout all the way to the top. Tight the nut to flush with steel washer and secure the valve by hand. 4. Gently secure the screws to lock the valve assembly in place use only a Phillips head screw driver.