0 YEAR MANUFACTURER'S LIMITED WARRANTY Al parts of this Kingston Brass faucet are warranted to the original retail purchaser to be fees from defects in material and workmanship for a period of Ten(10) years from the date of purchase as shown on the purchaser's receipt This warranty is limited to defective parts only, labor charges and/or damage resulting from improper installation, repair or replacements, as well as incidental and consequential damages connected therewith are excluded.
INSTALLATION INSTRUCTIONS For Use With KB's Widespread Lavatory Faucet with or without Pop-Up INSTALLATION ly lines to clear any debris. 2. Shut off both supply lines after flushing. Ned Tools: Teflon Tape Basin Wrench Adjustable Wrench Silicone Sealant Screwdriver 0 Spout Hardware Lock Nut -Washer Tee Connector 1. Remove the Tea Connector and spout mounting hardware from spout 2.
Replacement Parts: < Hat Cartridge FSCRP1971HC Cold Cartridge: FSCRP1S71CC B Hot Handle: KBH8B81NDLH SN Cold Handle: KBHBBB1NDLC CARE AND MAINTENANCE OF YOUR FAUCET Your Kingston Brass faucet has been finished to the most strict standards; however, due tn the high content of minerals in the water, your finish may appear dull and famished after time. These are some do's and don'ls to maintain the luster on your faucet for many years ta come. Do 1. Use a silicon based caulking when installing.
Mounting nut installation instr To install the mounting hardware: 1. Unscrew Both adjustment screws as much as possible without removing them. 2. Thread lockout onto the valve assembly and slip on the metal washer. 3. Once the valve assembly has been secured from the top, hand tighten brass Knockout all the way to the top. Tight the nut to flush with steel washer and secure the valve by hand. 4. Gently secure the screws to lock the valve assembly in place use only a Phillips head screw driver.