User Manual

Document No. 480ADT2000.A00
DT2000
Page 9 of 17
8. How to set the Timeout Lock Mode
To protect against unauthorised access when the DT2000 is connected to a host and
unattended, the DT2000 can be set to lock automatically after a pre-set amount of time.
In its default state, the DT2000 Timeout Lock feature is turned off. The Timeout Lock feature
can be set to activate (lock) anywhere between 1 and 99 minutes.
To set the Timeout Lock, follow steps in the table below.
\
9. How to disable the Timeout Lock Mode
To disable the Timeout Lock, follow steps in the table below.
Instructions
LED
LED Status
1. Unlock the DT2000 with the User PIN
Red solid LED changes to Green solid LED
indicating successful User PIN entry
2. Enable Options by pressing the KEY 3
times (triple-click)
Green and Blue LEDs blink together –
awaiting new instructions in OPTIONS
Mode
3. Within 10 seconds, enter the number 8 (tuv)
followed by the number 5 (jkl) button - (85)
Green and Blue LEDs continue to blink
together
4. Press KEY button once
Blinking Green LED
5. Within 10 seconds, enter the number 0
button twice (double-click) (zero zero) - (00)
Green LED continues to blink
6. Press the KEY button once
Green solid LED - Timeout Lock has been
disabled
Instructions
LED
LED Status
1. Unlock the DT2000 with the User PIN
Red solid LED changes to Green solid LED
indicating successful User PIN entry
2. Enable Options by pressing the KEY 3
button times (triple-click)
Green and Blue LEDs blink together –
awaiting new instructions in OPTIONS Mode
3. Within 10 seconds, enter the number 8
(tuv) followed by the number 5 (jkl)
button - (85)
Green and Blue LEDs continue to blink
together
4. Press KEY button once
Blinking Green LED
5. Within 10 seconds, enter the length of
User Timeout in 2 digits:
00 = 0 minutes (default)
01 = 1 minute
99 = 99 minutes, etc.
Green LED continues to blink
6. Press the KEY button once
Green solid LED - Timeout Lock has been
enabled