Owners manual

ManualsBrandsKingston ManualsComputers & Laptops32GB DataTraveler 2000 USB 3.1 Flash Drive - 32 GB - USB 3.1 - Blue - 256-bit AES

Document No. 480ADT2000.A00

DT2000

Page 8 of 17

6. How to enable Read-Only Mode

The DT2000 has a read-only mode that restricts write access to the drive. This is enabled by performing

the following steps.

Once activated, access is limited to read-only until write protect is disabled.

7. How to enable Read/Write Mode

Restricted write protect (read-only) access can be turned off with access restored to read/write.

This is enabled by performing the following steps.

Once activated, access is restored to the default read/write state.

Note: We have applied a naming convention to make it easy for you to remember the

keystrokes for each optional setting. In the table, above we have used numbers that represent

the ‘first letters’ of the optional feature name. For example, Read-Only = 7 (pqrs) 6 (mno).

Instructions

LED

LED Status

1. Unlock DT2000 with the User PIN

Red solid LED changes to Green solid LED

indicating successful User PIN entry

2. Enable Options by pressing the KEY button

3 times (triple-click)

Green and Blue LEDs blink together – awaiting new

instructions in OPTIONS Mode.

3. Within 10 seconds, begin to press number

7 (pqrs) followed by the number 6 (mno)

button (76)

Green and Blue LEDs continue to blink together

4. Press KEY button once

Blue LED quickly fades out to a solid Green - when

DT2000 is inserted into a USB port, the Green LED

blinks every two seconds indicating the drive is in

Read-Only Mode

Instructions

LED

LED Status

1. Unlock DT2000 with the User PIN

Red solid LED changes to Green solid LED

indicating successful User PIN entry

2. Enable Options by pressing the KEY button

3 times (triple-click)

Green and Blue LEDs blink together – awaiting

new instructions in OPTIONS Mode.

3. Within 10 seconds, enter the number 7

(pqrs) followed by the number 9 (wxyz)

button (79)

Green and Blue LEDs continue to blink together

4. Press KEY button once

Blue LED quickly fades out to a solid Green -

when DT2000 is inserted into a USB port, the

Green LED blinks every two seconds indicating

the drive is in Read/Write Mode