Datasheet

KVR13N9K2/16
16GB (8GB 2Rx8 1G x 64-Bit x 2 pcs.)
PC3-10600 CL9 240-Pin DIMM Kit
DESCRIPTION
ValueRAM's KVR13N9K2/16 is a kit of two 1G x 64-bit (8GB)
DDR3-1333 CL9 SDRAM (Synchronous DRAM), 2Rx8, memory
modules, based on sixteen 512M x 8-bit FBGA components per
module. Total kit capacity is 16GB. The SPDs are programmed
to JEDEC standard latency DDR3-1333 timing of 9-9-9 at 1.5V.
Each 240-pin DIMM uses gold contact fingers. The electrical
and mechanical specifications are as follows:
FEATURES
JEDEC standard 1.5V (1.425V ~1.575V) Power Supply
VDDQ = 1.5V (1.425V ~ 1.575V)
667MHz fCK for 1333Mb/sec/pin
8 independent internal bank
Programmable CAS Latency: 9, 8, 7, 6
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
Programmable CAS Write Latency(CWL) = 7 (DDR3-1333)
8-bit pre-fetch
Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or
MRS]
Bi-directional Differential Data Strobe
Internal(self) calibration : Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)
On Die Termination using ODT pin
Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE < 95°C
Asynchronous Reset
PCB: Height 0.740” (18.75mm) or 1.180” (30.00mm)
Document No. VALUERAM1231-001.B00 05/26/15 Page 1
Memory Module Speci cations
SPECIFICATIONS
selcyc 9)DDI(LC
Row Cycle Time (tRCmin) 49.125ns (min.)
Refresh to Active/Refresh 260ns (min.)
Command Time (tRFCmin)
Row Active Time (tRASmin) 36ns (min.)
Maximum Operating Power TBD W* (per module)
0 - V 49gnitaR LU
Operating Temperature 0
o
C to 85
o
C
Storage Temperature -55
o
C to +100
o
C
*Power will vary depending on the SDRAM used.
Continued >>
Important Information: The module defined in this data sheet is one of several configurations available under
this part number. While all configurations are compatible, the DRAM combination and/or the module height may
vary from what is described here.

Summary of content (2 pages)