User's Manual

Description:

1.ON/OFF button

2.Next/Volume +

3.Previous/Volume –

4.Play/Pause/Phone

5.MIC

6.AUX in Port

7.Charging Port

Included:

1.Speaker

2.USB Micro Tape C Charging Cable

3.3.5 mm Audio Cable

4.User Manual

Specifications

Supported Profiles: A2DP, HFP, AVRCP

Bluetooth Range:33ft (10m)

Dimensions: L:202 mm * W 76.6 mm* D 88.6 mm

Battery: Li-Ion 7.2V, 2000 mAh

Charging: 5V @ 1A

F2S

Wireless Speaker Instruction

Manual

Introduction

Thank you for choosing the F2S as your source for

entertainment! you can use this item with iPads,iPhones,

iPods and many types of smartphone to stream music ,

and enjoy handsfree calling.In order to get the best results

when using the device,please read this manual first before using.

Important Safety Information

1.Keep this product and its charging cable away from

excessive heat;

2.Do not operate this device with a damaged cable

or after it has malfunctioned or has been damaged

in any manner;

3.Do not disassemble your device;

1234

FCC ID: N7KF2S

Model Name: F2S

PAGE 1
Wireless Speaker Instruction Manual FCC ID: N7KF2S Model Name: F2S Introduction Thank you for choosing the F2S as your source for entertainment! you can use this item with iPads,iPhones, iPods and many types of smartphone to stream music , and enjoy handsfree calling.In order to get the best results when using the device,please read this manual first before using. Included: Description: 5 4 3 2 1 1.ON/OFF button 2.Next/Volume + 3.Previous/Volume – 4.Play/Pause/Phone 5.
PAGE 2
Operation Powering On Press and Hold " " button 2 seconds to power ON, the Blue LED will start to flash. If an Aux (3.5 mm) cable is connected to the unit, the Blue LED will turn off, and the Green LED will stay illuminated,notifying you, the uint is in Aux-In mode. Powering Off Press and Hold " " button 2 seconds to power OFF Bluetooth Mode Pairing The unit will automatically go into “Pairing Mode” when it is powered ON.
PAGE 3
FCC Caution. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.