User Manual Product Name: Bluetooth speaker Model: P10,P16 Manufacture: KINGTA TECHNOLOGY CO.
P10 Introduction Thank you for choosing the P10 as your source for e n t e r t a i n m e n t ! you can use this item with iPads , iPhones,iPods and many types of smartphone to stream music ,and enjoy handsfree calling.In order to get the best results when using the device,please read this manual first before using.
Description:
1.ON/OFF /Play/Pause/Phone button 2.multiple point button 3.Previous/Volume – 4.Next/Volume + 5.Bluetooth LED 6.MIC 7.Micro USB Charging Port 8.AUX in Port Included: 1.Speaker 2.USB Micro Charging Cable 3.3.5 mm Audio Cable 4.
Specifications Supported Profiles: A2DP, HFP, AVRCP,HSP Bluetooth Range: 33ft (10m) Dimensions: 120 mm x 120 mm x 60mm Battery: Li-Ion 3.7V, 2400 mAh Charging: DC5V±0.5/650mA Weight: 412g Operation Powering On Press and Hold " " button 2 seconds to power ON . Powering Off Press and Hold " " button 2 seconds to power off .
Making and Receiving Phone Calls When the unit is connected and paired to your device, the unit allows you to make or receive phone calls with its built-in microphone. Press “ ” to accept a call To end a call press “ ” Bluetooth Mode Pairing In order to pair your Bluetooth audio device to your Bluetooth Speaker for the first time, follow the steps below: 1. Make sure your Bluetooth audio source is held within ten meters of your speaker. 2.
5. Once paired, the “ “ will be solid and you can use your speaker to listen to audio from you Bluetooth sound source. *** P10 support reconnection function Note: Bluetooth Timeout :10 minutes Aux-In Mode Plug in the supplied 3.5 mm cable into the unit. The other end is connected to your device. The unit will automatically enter the Aux-In Mode . Please note music and volume can be controlled by your device.
Charging Attach the USB cable to the unit, and plug into any USB charger. If the unit is completely discharged, it will take approximately 4 hours to fully charge. These three key lights will be slow lighting alternating when charging , They will stop and keep lighting once charging . Note:There will be a beep when the battery is low and needs to be recharged.
Multiple point function ( TWS Wireless Stereo Mode ) If you have two pieces P10, you can use TWS to achieve wireless stereo combined playing music. 1、 Make sure two P10 is without any Bluetooth connection. 2、 Power on both speakers, and press “ “ button on one of the speaker, the two speakers will connect automatically with separate tone. When” ” LED blink on “ keeps solid the one speaker and “ on the other one, it means the TWS connection is successful.
Troubleshooting Unit doesn’t connect to device A tone is heard every few seconds Unit will not power on Unit doesn’t control track(s)/volume Speaker needs to be connected/re-paired to device Speaker needs to be charged Speaker needs to be charged Speaker needs to be in Bluetooth mode for full control Unit distorts at The devices’ volume needs to high volume be lowered
FCC Caution. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
