User's Manual

-7-
F.
:
Operations
1.Multiple receiver：long press PAIR/CH button will get into paring mode as E; press
PAIR/CH button shortly to switch the display as CAM1 → CAM2 → CAM3 → CAM4 →
Quad mode → CAM1…… sequentially by each pressing.
2.Single receiver：long press PAIR button will get into paring mode as E; press
PAIR button shortly to switch OSD on/off.
3.Multiple receiver：long press MODE button to get into SCAN mode, it will display
CAM1 → CAM2 → CAM3 → CAM4 → CAM1…… automatically every 5 seconds,
and press PAIR/CH button to stop; press MODE button shortly to switch OSD on/off.
4. Multiple receiver：long press PAIR/CH and MODE buttons until show up“Erase All
Pairing Data” , it will clear the pairing content ,so that it would be quick when you repair
G.Use Notes
1.Be sure the digital wireless camera and the receiver were connected to the
equipment correctly (e.g. Connect the digital wireless camera, and the receiver to
the TV or DVR).
2.When DC plug is pulled out from digital wireless camera or receiver, it needs to wait
for a few seconds to insert it again.
3.Adjust antenna to decrease interference. (vertical or horizontal)
4.In most situations, one pair has a better distance up to 150 meter(open site and line
of sight). When two pairs or more are used at the same time, it can automatically jump
to different channels. But the distance between pairs, preferably greater than 2 meter far.
5.If there are some reasons cause the devise stop, you can try to pull out and insert the
power plug again and make the devise re-link.
6.It is suggested to have 10 pairs mostly operated in same location, but the pairing can
not be at the same time.