User's Manual

-8-
Proble ms Possible Solution
Monito r(RX) shows TX power off; TX/RX distance is too long, so that transmis sion
“No Signal” signal is weak, please check and make it right
C heck all cable connections
M ake sure power plugs are pushed all the way in
No picture Check if the POWER LED of the digital wireless camera and
r eceiver is lighting or not? Their LINK LED should be lit
I f Their LINK LED should not be lit, you must re-pair their codes
f ollowing the E. instructio n of the ma nual
Ad just receiver and digital wireless camera antenna orientation
Try to place digital wireles s camera and receiver in a more close-in
Int erference lo cation
I f using a microwave oven, turn it off.
R emove microwave oven or wireless router from th e path between
d igital wireless camera and receiver
H.Troubleshooting
Multi Receiver:
Operating Frequency Band 2.403GHz~2.478GHz
Receiver Sensitivity -85dBm min.
Video Output Level 1±0.2V p-p ＠ 75 ohm
Modulation GMSK
Antenna Omni-directional
Power consumption 1.0W
Power supply 5V/1.2A or 12V/0.5A
Dimension 100mm*87mm*30mm
Weight 120g
Single Receiver:
Operating Frequency Band 2.403GHz~2.478GHz
I.Specifications