/5221F
5.8 4. 3. 4. 1. Channel Frequency CH1 5740MHz CH2 5780MHz CH3 5820MHz CH4 5860MHz 2. 5725~5875M 3. 4. 5. 6. 7. 8. 5725~5875M 12 5 12VDC 500mA KW5800 ±0.
5.8 5.8 12VDO (500mA) Notice : The changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, no change to the antenna or the device is permitted. Any change to the antenna or the device could result in the device exceeding the RF exposure requirements and void user’s authority to operate the device. e 3.
5.8 5.8 IR Sensor 8 12 8. Channel Frequency CH1 5740MHz CH2 5780MHz CH3 5820MHz Ch4 5860MHz 3.
.8GHz Wireless Multi - Receiver 5.
CHAPTER TABLE OF CONTENTS 8. Specifications 1.CE Statement…………………………………………….......... 2 Receiving Frequency Band 5740~5860GHz 2.Important-Safety precautions…………………………....... 2 Input Signal Level Range -85dBm ~-10dBm Antenna Connector SMA female connector Channel Input Gain Control Level +15~-30 dB adj. Noise Figure 3dB Video Output 1V p-p ＠ 75 ohm 3.Checking Contents of Box………………….…………........ 3 4. Panel Controls and Features………………………........... 4 5.
6.Orienting Device for Optimum Performance 1. Important-Safety Precautions ■ To This device should be placed on a flat, stable surface to prevent damage to it from falling. ■ Since all homes are different for optimum reception, additional slight rotate antenna may be necessary. ■ For optimum performance you maybe rotate the channel input gain control on the device individually when you use the device. 7.
■ Operation With 4 Monitors 3. Checking Contents of Box Make sure that all of the items shown as below are included with your 5.8 GHz Wireless Multi-Receiver System. If something is missing, please contact your dealer as soon as possible. 1. 2. 3. 4. 5. 5.8GHz Wireless Multi - Receiver KW5301 MANUAL 1. 4 Channels Multi-Receiver x1 2. 2.4GHz Wireless dipole Antenna X1 3. Power Adapter x1 4.
■ Operation With Digital Video Recorder and Monitor 4. Panel Controls and Features The following illustrations show the names of each component,button and switch connectors on the receiver.
5.Installation of the system Make sure the POWER switch is on the『OFF 』position before connection ■ Operation With Digital Color Quad Processor and Monitor OR This system is suggested to match following equipment: Be sure to set the power switch on the device and digital color quad processor and monitor to the off position before processor with the follow steps ˙Wireless Cameras. ˙Digital Color Quad Processor ˙Digital Video Recorder. 5. Install the metal sheet for magnetic antenna or 1.
