Owner manual
Kinivo BTC455 Bluetooth Car Kit with Multipoint
12
Note: After factory reset, you will need to remove the previous BTC455 pairing
from your Bluetooth device and repeat the pairing process.
Troubleshooting
1. Unable to pair to device / Device no longer connects
to BTC455
Ensure that the BTC455 car kit is in pairing mode by pressing and holding the
multifunction button for 8 seconds (alternating blinking red and blue LED). Now
open the Bluetooth conguration on the device you are trying to pair and scan
for Bluetooth devices. You should see the BTC455 - proceed to pair and connect
the car kit.
Please refer to the Operation section for Bluetooth Pairing.
2. No audio when playing music or when using phone
Please make sure of all of the following:
Check if the Bluetooth connection between your phone (or other Bluetooth
capable device) and the BTC455 is active.
Ensure that the car kit’s 3.5mm is plugged into the AUX port on your car
stereo.