User Manual
Press the Menu button to select DMX. Press and turn the control knob to select
individual digit settings for a valid address from 1-512. On the main display, “X” next to
DMX indicates DMX signal is present.
All manual controls are disabled once the DMX cable is applied and DMX is turned on.
To regain manual control with the DMX cable plugged in, set the DMX address to “0”.
19
DMX Settings
DIM Curve
Default is Square. Press control knob to change to Linear. Dim Curve applies
to how the input DMX Dim command is applied. In Linear mode an address of
127 = 50% Dim. Because single channel DMX is only 8 bit (0-255), the lower end of
the Dim curve has the same increment as the higher end. Square Dim applies
x^2 curve and allocates more values to the lower end of the Dim scale.
8/16 Bit DIM
Default is 8 Bit. 16 Bit Dim allocates an additional DMX channel for the Dim input,
one channel for the upper 8 Bits and another channel for the lower 8 Bits.
DMX Map
In White mode, DMX Map displays three DMX channel settings for DIM, CCT (Kelvin)
and G/M. In Color mode, DMX Map displays six DMX channel settings for DIM,
CCT (Kelvin), G/M, Gel, Hue and Saturation.
Note: If 16 Bit Dim is on, a total of 4 channels are displayed for White mode
(7 channels displayed for Color mode). The rst 2 DMX channels are assigned to
dimming. 1st channel = DIM MSB (Most Signicant Byte); 2nd channel DIM LSB
(Least Signicant Byte); 3rd channel = CCT (Kelvin); 4th channel = G/M.
(In Color mode, 5th channel = Gel, 6th channel = Hue; 7th channel = Saturation.)