User Manual

21
Tip: DMX xtures without wireless capability can be daisy chained with DMX cables to
the wireless xture.
Enable
Enables wireless DMX. Default is OFF. Press the control knob to turn Enable ON.
The following are examples of what will be seen in the main display when wireless
DMX is Enabled:
1) “R” with no signal bar: Indicates wireless DMX is enabled, but there is
no connection to a transmitter.
2) “R” with signal bar: Indicates wireless DMX is enabled; the xture is connected
to a transmitter, but no valid DMX is currently being transmitted.
3) “RX” with signal bar: Indicates wireless DMX is enabled; the xture is connected
to a transmitter and valid DMX is currently being transmitted.
All manual controls are disabled when wireless DMX is enabled.
Unlink - Press 3 secs
Press the control button for 3 seconds to unlink from wireless DMX transmitter.
Status – Unlinked, Linking, Linked
This shows the status of the wireless connection. Default is Unlinked. When linking
is initiated from the transmitter, the status will display Linking. Once connected, the
status will change to Linked. If the xture is linked to a transmitter that is not present,
the status will show Linking.
Signal
Indicates signal strength of wireless connection. In main display, up to 5 bars indicate
signal strength.
Note: Controller must be powered on. In addition, the wireless transmitter must be
connected to a DMX controller with a valid DMX output.