Manual
11
Power & Fuse Requirements
POWER
Provide 120VAC or 230VAC depending on model.
Do not dim the xture through a dimming circuit.
If powering the xtures through a dimming board,
set the dimmer prole to non-dim.
FUSE
Fuse provides circuit protection. Note: If Fuse is
“blown” or “open”, replace with same type of fuse
rating as marked.
Load Considerations:
The Kino Flo ballasts used in the VistaBeam are not power factor corrected.
They will draw double the current on the neutral from what is being drawn on the
two hot legs. On large installations it may be necessary to double your neutral run
so as not to exceed your cable capacity.