User Manual

Getting familiar with the Practilite 602
1. OLED Display - dimming (%) and colour temperature readout (Kelvin value)
2. BOOST button – activates intensifed lumen output for 4500K (activates additional cooling)
3. ON/OFF button – toggles between standby and operational mode. In standby mode the
instrument is recogniseable by remote control and can be turned on, it will return to it’s
previous working state. Constant blinking of the red indicator means the power is too low.
4. Boost mode, upper LED indicator
5. Bluetooth LE connection, middle LED indicator
6. Power ON/OFF, Bottom LED indicator
7. Colour Balance knob* – changes the colour balance continuously from 3000 to 6000K
8. Dimmer knob* – dims the LED from 5 to 100% (140% in Boost mode)
9. Focusing knob – manual focus control for beam angle. Notice that focusing can not be
performed from the App.
10. DC input (12-28V) 4-pin male XLR socket (leftmost pin „-“, rightmost pin „+“)
11. Yoke tightening lever
12. Yoke
13. Light stand receiver, accepts 5/8” (16mm) Baby Pin / spigot
14. 3.5“ (80mm) borosilicate Fresnel lens
15. Front cooling slots, vent exhaust
16. Back cooling grille, air intake
*These physical control knobs will retain their dialed in value but will be overridden by remote
application once activated.
Status indicators
Boost mode ON (green), Boost in Standby Mode (orange), battery too low (red blinking).
Not connected to remote host (red), connected (green), connected in standby mode (orange)
Power ON (green), Standby (red)
•
•
•