Installation Guide

Cleaning and Care

Care should be exercised when cleaning this product. Although its finish is durable, it can be

damaged from harsh abrasives and cleaning pads. To clean, use light, non-abrasive cleaning

solution or cleaning polish.

Package contents:

Accessory list:

1) Tub filler spout

2) Mixer

3) Standpipe

4) Escutcheon

5) Inlet supply line (2 pcs)

6) Permanent seat

7) Shower hose

8) Expansion screw (3 pcs)

9) Hand shower

PAGE 1
Cleaning and Care Care should be exercised when cleaning this product. Although its finish is durable, it can be damaged from harsh abrasives and cleaning pads. To clean, use light, non-abrasive cleaning solution or cleaning polish.
PAGE 2
Installation steps 1 Place the escutcheon (#4) over the standpipe (#3) and push it to the base, then turn the parmanent . seat to standpipe 2 Ture the inlet supplies to mixer, verify the hot one with red line and the cold one with the blue line.
PAGE 3
Making sure the prongs on the top of standpipe (#3), insert into the hole of the mixer (#2). Install the set and tighten into the standpipe (#3) 4 Mark the locations for the screws with a pencil. With an electric drill , drill three holes for the expansion screws (#8) in the floor. Place the expansion screw (#8) into the holes. Connect the flexible supply lines (#5) to the water supplies.
PAGE 4
5 Ensure the standpipe (#3) sits flush against the finished floor surface. Then secure the standpipe(#3) using screws (#8). Push the escutcheon (#4) over the standpipe (#3) base so that it sits flush against the finished floor surface. 6 Connect one end of the shower hose (#7) to the mixer (#2) and the other end to the showerhead (#9). Ensure the washer is placed into each end for seal.