User Manual

M0188-01Model 3000
6-4 Rev. 6/11
TM
KPM I Monitor Operation
FIELD OPERATION
(MTR28e/MTR28c/MTR28d/MTR28b)
Press ON/OFF key to turn monitor on
and off.
Information regarding each section is
displayed alternately every 5 seconds.
REAR/FRONT CONFIGURATION
• Press SELECT key once to show
REAR section only.
•Press SELECT key a second time to
return to each section being displayed
alternately every 5 seconds.
• PressSELECTkeyathirdtimetoshow
REAR section only again.
LEFT/RIGHT CONFIGURATION
• PressSELECTkeyoncetoshowLEFT
section only.
• Press SELECT key a second time to
show RIGHT section only.
• PressSELECTkey athird timetore-
turn to each section being displayed
alternately every 5 seconds.
NOTE: SELECT key has no function when only a
single section is being used.
Press VOLUME key to increase or de-
crease volume. See “Changing The Au-
dible Alarm Volume”.
Press the OK key to silence alarms. See
“Warnings And Alarms”.
SETUP FRONT
REAR
ON
OFF
OK
VOLUME
®
KPM I
SELECT
01229910
FLASHING
(LEFT) (RIGHT)
FLASHING
LEFT RIGHT
SETUP
ON
OFF
OK
VOLUME
®
KPM I
SELECT
01229911
(FRONT) (REAR)
FLASHING
FLASHING
PROGRAMMING/CONNECTING SEED TUBES
STEP 1 All seed tubes w/sensors must be
disconnected from the harness and monitor
must be off.
STEP 2 Press ON key. The monitor automatically
enters the setup procedure. If the monitor
was accidentally powered on with no
sensors attached, the user can turn the
monitor off at this point and the previous
configuration is not lost.
STEP 3 Press SELECT key. Each time you press
the SELECT key the mode toggles between
rear/front and left/right. The selected
display will be solid and the configuration
not currently selected will be flashing. By
default the monitor starts in rear/front
mode.
NOTE: Model 3000 planters use rear
configuration only. When Interplant
®
Package
rows are in use, select rear/front configurations.
When all rows can be viewed on a single display
(rear), pressing the select key has no function.