Manual

M0241-01Model 3200
6-38 Rev. 7/12
TM
KPM III Monitor Operation
When correct distance pulse count is known, calibration is not
needed and the following steps may be used.
STEP 1
Turn knob or use arrow keys to highlight ‘’10. Calibrate
Speed Sensor” and press knob or Enter key
STEP 2 Turn knob or use arrow keys to highlight “3. Change
Distance Pulse Count” and press knob or Enter key.
Highlight “Enter Pulse Count” line and press knob or
Enter key and a drop down key pad will appear.
Status
Plant
About
Setup Mode
Configuration:
Effective row spacing: 15.0
Front / Rear
1. General Settings
2. Seed Meter Settings
3. Row Unit Alarm Levels
4. Setup Data Logging
5. Configure Planter Monitor
6. Add New Muxbus Sensors
7. Add Single Interplant Row
8. Select Speed Sensor
9. Sensor Setup
Logdata
10.Calibrate Speed Sensor
NOTE: Distance Pulse Count will vary from above example.
STEP 3 Turn knob or use arrow keys to highlight the first digit
of the average pulse count and press the knob. The
number will appear in the “Enter Pulse Count” line.
Highlight the next digit of the number and press the
knob. Repeat this procedure until the entire number
is entered then press Enter key.
STEP 4 Turn knob or use arrow keys to highlight “OK” then
press knob or Enter key to return to the “Calibrate
Speed Sensor” screen.
STEP 5 Press F6 key next to “Done” to return to “Setup
Mode” screen.
Done
1. Tractor stopped, Start calibration
2. Tractor stopped, Calibration Done
3. Change Disance Pulse Count
Distance Pulse Count: 185000
English: Drive exactly 330 feet.
Metric: Drive exactly 100 metres.
Calibrate Speed Sensor
Execute step 1 and 2
Effective row spacing: 15.0
Enter Pulse Count
Distance Pulse Count
Cancel
185000
OK
Monitor will display current pulses per mile/kilometer using a 6
digit, no decimal place format labeled “Distance Pulse Count”.
Turn knob or use arrow keys to highlight “Change Pulse Count”
then press knob or Enter key. The “Distance Pulse Count” box
will appear.
• When “Enter Pulse Count” value is highlighted press knob
or Enter key and a drop down key pad will appear. Turn
knob or use arrow keys to highlight “0”, zero, and press
knob or Enter key. Turn knob or use arrow keys to highlight
“OK” and press knob or Enter key to return to the “Calibrate
Speed Sensor” screen.
NOTE: If Distance Pulse Count number starts to count pulses
with the tractor not moving, check radar distance sensor for
vibration or other interference.
Done
1. Tractor stopped, Start calibration
2. Tractor stopped, Calibration Done
3. Change Disance Pulse Count
Distance Pulse Count: 185000
English: Drive exactly 330 feet.
Metric: Drive exactly 100 metres.
Calibrate Speed Sensor
Execute step 1 and 2
Effective row spacing: 15.0
Enter Pulse Count
Distance Pulse Count
Cancel
185000
OK
Done
1. Tractor stopped, Start calibration
2. Tractor stopped, Calibration Done
3. Change Disance Pulse Count
Distance Pulse Count: 185000
English: Drive exactly 330 feet.
Metric: Drive exactly 100 metres.
Calibrate Speed Sensor
Execute step 1 and 2
Effective row spacing: 15.0
Enter Pulse Count
Distance Pulse Count
Cancel
0
2
0
1 2 3
C
4 5 6
7 8 9
. 0
-
OK