Manual

TM
Model 3200M0241-01
6/11 2-11
Machine Operation
HYDRAULIC WING FOLD FIELD OPERATION TO TRANSPORT
WARNING
Planter wings may swing suddenly and cause death or serious injury.
Do not stand between wings and frame when folding or unfolding
planter. Planter must be on a level surface in all directions.
SUMMARIZED FIELD TO TRANSPORT SEQUENCE
• Raise row markers and lower planter.
• Position turnbuckle to hold frame in level position.
• Move selector valve to “FOLD”.
• Loosen wing lock eyebolts and swing over to unlock wings.
• Raise planter.
• Install lockups on center lift cylinders.
• Retract wing lift cylinders.
• Hydraulically fold wings forward. Lock wings in place.
• Move selector valve to “MARKER”.
NOTE: Read following information for detailed instructions.
NOTE: Use special wrench stored on inside of hitch for center turnbuckle and wing lock eyebolt
hex nuts. Always return wrench to storage location after use.
1. Fold row markers to raised transport position and lower planter to ground.
2. Swing center turnbuckle into position to hold planter frame level and tighten slightly. Install lockup pin in storage
location
Center turnbuckle installation
NOTE: Hydraulic pressure will prevent selector valve from
moving. Release hydraulic pressure from system before
attempting to move selector valve handle.
3. Move selector valve to “FOLD”.
Selector valve