Installation Instructions

ManualsBrandsKipit ManualsRFID SystemsRFID Liner Tote Device

KIPIT [name of device]

[model No.]

[FCC ID: …]

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

CAUTION: CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE

PARTY RESPONSIBLE FOR COMPLIANCE COULD VOID THE USER'S AUTHORITY TO

OPERATE THE EQUIPMENT.

Responsible party: Kipit, Inc. [Address] [Telephone or internet contact information]

Summary of content (4 pages)

PAGE 1
KIPIT [name of device] [model No.] [FCC ID: …] This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CAUTION: CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE COULD VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT. Responsible party: Kipit, Inc.
PAGE 2
A. INSTALLATION AND OPERATION NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PAGE 3
I. II. III. IV. I. II. III. IV. V. Take reader out of the packaging. Connect the reader to a power source using the USB cable to activate it. A light will flash green on the device. Fully charge reader until the light turns from flashing green to solid green. Disconnect from power source. 4. Placing the reader inside your bag Place reader inside bag. Velcro strips must face the sides of the bag. Peel cover off Velcro strips. Adjust the reader so it covers the bottom and sides of the bag.
PAGE 4
The Kipit device complies with portable radiofrequency (RF) exposure limit in the USA set forth for an uncontrolled environment and is safe for intended operation as described in this manual. Further RF exposure reduction can be achieved if the product is to be kept away from the user body when device is not in use (for example, do not sleep on a bag with an active device placed in it).