Instructions / Assembly

ITEM #: RVL-CP3572-4
IMPORTANT SAFETY INSTRUCTIONS
• To avoid injury or damage, mount only on a surface that is sturdy.
• To avoid electric shock, make sure the electricity is turned off at the main
circuit breaker panel. If you are replacing an existing fixture, turn off the
following in order: fixture, wall switch, and main fuse or breaker box.
Note: Some types of fuses must be unscrewed to shut the power off.
• If you are unclear as to how to proceed, please consult a licensed
electrician.
UNPACK THE FIXTURE: Check the contents of the box. Box should contain all items on the parts diagram.
For any replacement parts or installation issues, please Contact Us!
Email: [e-mail]
Facebook/Instagram: @KiraHomeDecor
Phone: [phone]
INSTALLATION INSTRUCTIONS
1. Measure Canopy (D) height with measuring tape. Adjust Canopy Screws (E) on Mounting Plate (A) to the
height of measured Canopy (D) plus 1/4" to allow them to protrude through Canopy (D) during installation.
Lock Canopy Screws (E) in place with the hex nuts.
2. Secure Mounting Plate (A) to the junction box (not included) using Mounting Screws (B) provided. Ensure
Mounting Plate (A) is positioned with the threads of Canopy Screws (E) pointing down towards the floor.
3. Place Canopy (D) flush against ceiling with Canopy Screws (E) protruding through the holes in Canopy (D).
Verify that 1/4” of the threaded portion of Canopy Screws (E) are visible. Remove Canopy (D) and set it
aside.
Note: If 1/4" of Canopy Screws (E) are not visible, remove Canopy (D) and re-adjust Canopy Screws
(E) to proper height and lock them in place with the hex nuts.
4. Secure Center Rod (J) to the top of Socket Assembly (K). Pull through any necessary Wire (H). Spread the
sockets on Socket Assembly (K) to create chandelier design.
5. Remove Arm Screws (N) from Top Ring (I) and Bottom Ring (L). Line up the holes on the arms of Socket
Assembly (K) with the holes on Bottom Ring (L). Place the holes on Arms (M) over the holes on Bottom
Ring (L) and secure in place with Arms Screws (N). Secure all Arms (M) to all holes on Bottom Ring (L).
6. Place the notches on Top Ring (I) through the holes on Arms (M) and secure in place with Arm Screws (N).