Installation Guide

ITEM #: RVL-CP5972-3
IMPORTANT SAFETY INSTRUCTIONS
• To avoid injury or damage, mount only on a surface that is sturdy.
• To avoid electric shock, make sure the electricity is turned off at the main
circuit breaker panel. If you are replacing an existing fixture, turn off the
following in order: fixture, wall switch, and main fuse or breaker box.
Note: Some types of fuses must be unscrewed to shut the power off.
• If you are unclear as to how to proceed, please consult a licensed
electrician.
UNPACK THE FIXTURE: Check the contents of the box. Box should contain all items on the parts diagram.
For any replacement parts or installation issues, please Contact Us!
Email: [e-mail]
Facebook/Instagram: @KiraHomeDecor
Phone: [phone]
INSTALLATION INSTRUCTIONS
1. Secure Mounting Plate (A) to the junction box (not included) using Mounting Screws (B) provided. Ensure
the attached Screw Collar Loop (E) is pointing down towards the floor.
2. Remove Threaded Ring (F) from Screw Collar Loop (E) by unscrewing it in a counter-clockwise direction.
Set Threaded Ring (F) aside.
3. Place Canopy (D) against the ceiling with Screw Collar Loop (E) protruding through the hole in Canopy (D).
Adjust Screw Collar Loop (E) and the hex nut above it until 3/8" of the threaded portion of Screw Collar
Loop (E) is visible. Remove Canopy (D) and set it aside.
4. Secure Pendant Loop (I) to the top of Fixture Body (J) by screwing it in a clockwise direction. Pull through
any necessary Wire (H).
5. Remove Center Screws (P) from inside Arms (L). Spread out Arms (L) on Fixture Body (J) evenly to create
the chandelier design.
6. Slide Center Ring (M) up within Arms (L). Align holes on Center Ring (M) with the holes on Arms (L) and
secure with Center Screws (P).
7. Align the holes at the bottom of Arms (L) with the holes on Bottom Ring (N). Secure in place with Bottom
Screws (O).