Instruction Manual

43
ADJUSTING THE BRUSH ROLL HEIGHT (cont)
Place the brush back into the nozzle making sure both plastic
Brush Roll ends are set to the same number of notches (1, 2, or 3).
Replace the Rug Plate by placing it on the front of the bumper first and
then pulling it over the bumper on rear of Power Nozzle

25 . Secure the
Rug Plate using the two latches that hold it in place.
Using the handle, hook the belt onto the Belt Lifter

20 and turn the
Belt Lifter to the left (counter-clockwise) until the red arrows line up.
This will stretch the belt in preparation for returning the nozzle to the
Sentria
®
system. ❏
4
WHEEL WEAR/ REPLACEMENT
Kirby
®
wheels are made with a pliable tread that is designed to prevent
carpet wear and prevent damage to non-carpeted floors. After extended
periods of use, the tread on the wheels will wear out and the wheels will
need to be replaced.
Check wheel tread occasionally to determine if the wheels need to be
replaced. The tread material is lighter in color than the plastic wheel
itself. If any of the darker plastic wheel is showing through the tread,
the wheels need to be replaced. The wheels are not user-replaceable.
Contact your nearest authorized Kirby
®
Service Center for prompt,
courteous wheel replacement. ❏
CORD REPLACEMENT
If the electrical cord connecting the Sentria
®
system to the outlet
becomes cut or frayed over time, DO NOT USE THE UNIT. Contact
your authorized Kirby
®
Service Center immediately for replacement.
Avoid damage to your cord by being careful not to run over it with your
Sentria system. Also, unplug your unit by grasping the plug at the end
of the cord rather than pulling on the cord itself. ❏
HEADLIGHT REPLACEMENT
If one or more of the three LED lights in your Headlight Assembly
burn out, please contact your authorized Kirby® Distributor for
replacement. ❏
SERVICE TIP
Keep the entire Brush Roll and belt track clear of lint, string, hair and other
debris build-up. This will allow the Brush Roll to perform at its fullest
potential. ➤
Keep motor shaft free from lint, hair, and debris build-up. ❏
Operating/Maintenance Tips
Questions and Answers/Troubleshooting