Data Sheet

Tripod Quick Release Assembly
Tripod quick release is constructed from 6061-T6 aluminum and stainless.
The mounting hole size will accept a 3/8-16 tripod stud. Also offered in the
quick release is an anti-rotation lock screw, over-sized safety stop pockets
and a captive quick release knob.
Please note: The KES tripod head quick release assembly does accept both
the small and large KES tripod head mounting plates.
www.kirkphoto.com
800.626.5074 • 260.665.3670
333 Hoosier Drive,
Angola, IN 46703-9336
One tripod, several tripod heads, and tired of screwing them on and off?
We have the perfect solution for you.
Our new tripod head quick release system will
give you the ability to quickly and easily switch
between ball heads, pan heads, gimbal heads
and more.
Our system consists of two parts – the tripod
quick release and our tripod head quick release
plates, both shown below.
Installation is simple. By installing the quick
release on the top of your tripod and installing
one of the two quick release plates on your tripod
head that best suits your needs – you will be up
and going in no time.
The tripod head quick release plates offer a
3/8-16 mounting bolt, anti-rotation screw and
two over-sized safety stops to ensure a perfect
and safe assembly.
Depending upon the base size of your tripod
heads, decide which assembly will work best
for your needs and follow the steps below.
Tripod Head Quick Disconnect Plates
Follow the technique shown to decide which
quick disconnect plate will suit your needs.
The small quick disconnect plate is recommended
for tripod head bases 2.250 inches and under
The large quick disconnect plate is recommended
for tripod heads 2.250 and over.
Tripod Head
Quick Release System