Modified Sinewave Power Inverter 1000/1500 MW 1210, MW1215 True Sinewave Power Inverter 1000/2000 SW 1210, SW 1220 Owner’s Manual Modified Sinewave Series True Sinewave Series
For safe and optimum performance, the Power Inverter must be used properly. Carefully read and follow all instructions and guidelines in this manual and give special attention to the CAUTION and WARNING statements. PLEASE KEEP THIS MANUAL FOR FUTURE REFERENCE Disclaimer While every precaution has been taken to ensure the accuracy of the contents of this guide, KISAE Technology assumes no responsibility for errors or omissions.
Table of Contents 1. INTRODUCTION................................................................................................ 4 2. PRODUCT DESCRIPTION ............................................................................... 5 3. INSTALLATION ................................................................................................. 5 4. UNIT OPERATION............................................................................................. 9 5. TROUBLESHOOTING .................
1. INTRODUCTION Thank you for purchasing the KISAE Power Inverter. With our state of the art, easy to use design, this product will offer you reliable service for providing AC power and 5V USB power for your home, cabin, RV or Trailer. The KISAE Power Inverter can run many AC-powered appliances when you need AC power anywhere. The 5V USB power can charge many USB powered devices. This manual will explain how to use this unit safely and effectively.
against harmful interference in a residential installation. This equipment generate, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
DC Input Rear Panel Fan opening DC Input Terminals Ground Terminal Picture shown MW1210 Material Prepare for Installation Typical Wiring block diagram of the Power Inverter: Pos + AC & USB LOADS Power Inverter (MW 1210, MW 1215, SW1210, SW 1220) Disconnect Switch Neg - Fuse or Circuit Breaker 12 V Battery Bank (Charger system sold separately is required to charge the battery bank when battery is discharged) 12V Battery Bank: The use of deep cycle battery is highly recommended for power inverter
terminal. For the grounding cable connected between the power inverter chassis to the earth ground, use a matching cable size as used on the DC Input Cable section. Installing the Power Inverter System WARNING: Electrical Shock Hazard The unit ‘On/Off’ switch does not disconnect the DC power from the battery. Use the DC Disconnect Switch or disconnect the DC input cables connection to disconnect the DC power from the battery before working on any circuits connected to the unit.
Connect the other side of the cable to the common grounding point. Power Inverter DC Input Connection: CAUTION: Reverse the DC Input terminal will damage the unit and cannot be repaired. Damage caused by reverse polarity connection is not covered by the warranty. Connect one end of the negative DC input cable to the Power Inverter DC negative terminal. Connect the other end of the negative DC input cable to the battery negative terminal. Make sure the Disconnect Switch is in the OFF position.
4. UNIT OPERATION WARNING: RISK OF EQUIPMENT DAMAGE For MW 1210, MW 1215: Do not plug surge-protected power bars into the unit’s 120 VAC outlets. The surge protected components on the surge-protected power bar may not like the modified sine wave output generate by the inverter. Do not connect an AC power source like utility power or generator to the unit 120 VAC outlets. Turn ON and OFF the 120 VAC and USB Press and hold the “Power/Select” button for 1 second until a beep is sounded.
generate by the inverter, those appliances may not work or may be damaged if they are connected to the inverter. If you are unsure about powering any device with the inverter, contact the manufacturer of the device. Estimate Run time on Load Following run time is an estimate based on using a 12V-120AH battery bank for reference. Actual run time may vary. Load Consumption Estimate Run time Cordless Phone 5W 180 hrs Clock/Radio 8W 135 hrs Table Lamp 40W/60W 27 hrs/ 18 hrs Freezer (8.8 cu. ft.
6. SPECIFICATIONS Note: Specifications are subject to change without notices.
7. WARRANTY One Year Limited Warranty The limited warranty program is the only one that applies to this unit, and it sets forth all the responsibilities of KISAE. There is no other warranty, other than those described herein. Any implied warranty of merchantability of fitness for a particular purpose on this unit is limited in duration to the duration of this warranty.