Installation Instruction

11
2. Orient the brackets depending on the width (30" or 36") of
your cabinet as depicted in the images below, then secure
them with three 4 x 15 mm screws on the selected thickness
hole.
3. Using the bracket as a template, mark four spots in each
side of the cabinet to drill 1/8" (3 mm) pilot holes.
NOTE: Align the bracket with the front and the back side
of the cabinet and ensure that the bottom of the bracket is
installed tight against the bottom of the cabinet.
4. Attach a bracket using four 4.5 x 13 mm screws to each side
of the cabinet, and tighten.
Additional washers in hardware package are supplied as
spacers for cabinet walls thinner than 1/2" (13 mm).
30" width cabinet 36" width cabinet
A A
A
A. Pilot holes
Bracket Orientation for 36" (91.4 cm) Cabinet
A. 36" (91.4 cm) cabinet
B. Screws - 4.5 x 13 mm (8)
C. Washers (optional)
D. Mounting bracket (4) (position for 36" [91.4 cm] cabinet)
5. Install the vent system according to the method needed.
6. Use caulking to seal the exterior wall or roof opening.
Bracket Orientation for 30" (76.2 cm) Cabinet
A. 30" (76.2 cm) cabinet
B. Screws - 4.5 x 13 mm (8)
C. Washers (optional)
D. Mounting bracket (4) (position
for 30" [76.2 cm] cabinet)
A
B
C
D
A
B
C
D
A. 4 x 15 mm screws