Use and care guide

15
CMD + SHIFT CLICK TO CHANGE COPY
English
OPERATING THE COMMERCIAL IMMERSION BLENDER OPERATING THE COMMERCIAL IMMERSION BLENDER
For best results, insert Commercial
Immersion Blender with blending arm
attached into the pot or bowl containing
ingredients at an angle. Use the removable
secondary handle for better stability. Stop
the Commercial Immersion Blender before
removing it from the pot or bowl
to avoid splashing.
Rest the Commercial Immersion Blender on
the bottom of the pot or bowl momentarily,
then hold at an angle and slowly draw it
upwards against the side of the pot or bowl.
As the Commercial Immersion Blender is
drawn up you will notice the ingredients
from the bottom of the pot or bowl being
drawn up. When the ingredients are no
longer being drawn up from the bottom,
return the Commercial Immersion Blender
to the bottom, and repeat the process until
the ingredients are the desired consistency.
Blending
Drawing up
5. Press the LOCK switch to unlock the
Commercial Immersion Blender, then
press and hold the Power/pulse trigger
to activate.
Using a light circular motion from your
wrist, draw the Commercial Immersion
Blender up slightly and let it fall again
into the ingredients. Allow your wrist
motion and the weight of the Commercial
Immersion Blender to do the work. Use
the removable secondary handle, if
needed, for extra stability while mixing.
Power/
pulse trigger
Lock
6. When blending is complete, release
the Power/pulse trigger before removing
the Commercial Immersion Blender
from the mixture.
7. Unplug immediately after use, before
removing or changing attachments.
IMPORTANT: If a piece of food becomes
lodged in the guard surrounding the blade,
follow these instructions:
1. Release the Power/pulse trigger and
unplug the Commercial Immersion
Blender.
2. Use a spatula to remove the food
lodged in the plastic guard. Do not use
yourngerstoremovelodgedfood.
3. Plug the Commercial Immersion
Blender back into the electrical outlet
and resume operation.
W10859533A_01_EN_v18.indd 15 2/6/17 3:53 PM