Operation Manual

13
English
Care and Cleaning
The Blender pitcher, culinary jar, locking
collar and blade assembly can be easily
cleaned as individual components or
together without disassembly.
•CleantheBlenderthoroughly
after every use
•DonotimmersetheBlender
base or cord in water
•Donotuseabrasivecleansers
or scouring pads
To Clean Individual Components
1. Lift the pitcher (or culinary jar) assembly
in a straight, upwards motion off the
Blender base. Place assembly on a hard
surface. Then, while holding locking
collar, rotate pitcher (or culinary jar)
counterclockwise, two clicks, to separate
locking collar and blade assembly, and
sealing ring from the pitcher (or culinary
jar). Wash components with soapy water.
Rinse and wipe dry.
NOTE: Hand wash the lid, ingredient cup,
locking collar, and sealing ring — these items
may be damaged in the dishwasher. Pitcher
can be placed in the bottom rack of an
automatic dishwasher.
2. Wipe the Blender base and cord with
a warm, sudsy cloth; wipe clean with
a damp cloth, and dry with a soft cloth.
To Clean Without Disassembly
1. Put the pitcher (or culinary jar) on the
Blender base, fill half full with warm
(not hot) water, and add 1 or 2 drops
of dishwashing liquid. Put the lid on the
pitcher (or culinary jar), press the STIR
( ) speed setting, and run the Blender
for 5 to 10 seconds. Remove the pitcher
(or culinary jar) and empty contents.
Rinse with warm water until clean.
2. To clean the lids and ingredient cup,
wash in warm soapy water, then rinse
and dry thoroughly.
3. Wipe the Blender base and cord with
a warm, sudsy cloth; wipe clean with
a damp cloth, and dry with a soft cloth.
Sealing
Ring
Pitcher
Locking
Collar
and Blade
Assembly
Culinary
Jar
W10482505A_01_EN.indd 13 4/2/12 12:33 PM