Manual

Using a Phillips screwdriver, remove the 4 screws at the back

of grill from inside the grill (2 screws on each side of the

rotisserie infrared burner).

5= Use 24 mm wrench to remove the orifice nut.

Remove the access cover at the back of the grill hood by

removing the 4 screws (2 screws on each side of the

rotisserie infrared burner).

A. Access cover

Using a Phillips screwdriver, remove the 2 screws holding the

spider guard to the burner.

A. 2 screws

A. Onfice nut

Take out the orifice support, and then use a 6 mm socket and

wrench or 6 mm nut driver to remove the LP orifice at the end

of the supply pipe. Replace with Natural gas orifice.

....S

A. Orifice support

B. Orifice

IMPORTANT: Check that the orifice is properly installed

inside of the supply pipe.

7. Reinstall the spider guard, access cover, and wind baffle.

Change the Sear Burner Orifices

1. Remove the screw securing the igniter and the 2 searing side

burner screws.