Manual

Check and clean burner/venturi tubes.
1. ove grill grates and flame tamers.
2. _._ove the 2 screws that hold the burner in place.
Hemove gas burner from the grill.
A
2
A. 2 screws
3. Use a flashlight to inspect into the burner through the
burner inlet to ensure there is no blockage. If any
obstruction is seen, use a metal coat hanger that has
been straightened to clear them.
4. After inspecting the inside of burner for blockage,
reassemble burner by sliding the middle tube of the gas
burner over the gas orifice.
A
KNOBS AND FLANGE AREA AROUND KNOBS
IMPORTANT: To avoid damage to knobs or flange area around
knobs, do not use steel wool, abrasive cleaners, or oven cleaner.
Do not soak knobs.
Cleaning Method:
• Mild detergent, a soft cloth and warm water.
• Rinse and dry.
CONTROL PANEL GRAPHICS
IMPORTANT: To avoid damage to control panel graphics, do not
use steel wool, abrasive cleaners or oven cleaner.
Do not spray cleaner directly onto panel.
Cleaning Method:
• Clean around the burner labels gently; scrubbing may remove
printing.
• Mild detergent, soft cloth and warm water.
• Rinse and dry.
TROUBLESHOOTING
5.
\\
A. Burner/orifice connection
Reattach gas burner using 2 screws.
SEARING SIDE BURNER
Cleaning Method:
• Clean the exterior of the sear burner with a wire brush.
ROTISSIERE BURNER
Cleaning Method:
1. Light the rotisserie burner. See the "Using Your Rotisserie
Burner" section.
2. Close the grill hood.
3. Leave the burner on high for approximately 30 minutes.
4. Turn knob to OFF and let cool completely.
5. Brush off ash particles from the rotisserie burner.
DRIP TRAY
IMPORTANT: The drip tray should only be removed when grill is
completely cool.
The full-width drip tray collects grease and food particles that fall
through the grill. Clean often to avoid grease buildup.
Cleaning Method:
• Remove tray and set on a flat surface.
• Wipe excess grease with paper towels.
• Mild detergent and warm water. Rinse and dry thoroughly.
• Replace tray.
Grill will not light
• Is the 20 Ib LP gas fuel tank valve turned off?
Turn the 20 Ib LP gas fuel tank on.
• Is the grill properly connected to the gas supply?
Contact a trained repair specialist or see Installation
Instructions.
Is there gas in the 20 Ib LP gas fuel tank?
Check the gas level.
Is the igniter working?
Check that the igniter battery is properly installed or check to
see if the battery needs to be replaced. See the "Replacing
the Igniter Battery" section.
Check to see if the grill will match-light. See "Manually
Lighting the Grill and Searing Side Burner" in the "Outdoor
Grill Use" section.
Check for loose wire connections to the igniter or electrodes.
Check to see if debris is blocking the electrodes.
If a spark occurs anywhere but the igniter tip, replace the
igniter.
Burner flame will not stay lit
• Is the gas supply fully turned on?
Check that the 20 Ib LP gas fuel tank valve is fully open.
• Is the gas supply in the 20 Ib LP fuel gas tank low?
Check the gas level.
• Is the burner properly installed and in good condition?
Check that the burner is installed properly. Check for defects
in the burner.
28